Napoleon Fireplaces EF39S - Manuel (Page 14)

W415-0924 / C / 09.28.12
14
EN
6.1 REPLACING THE FLAME GENERATION LIGHT BULBS
A. Remove the 6 screws on the back plate of the
appliance near the bottom. Open back plate
from the top.
B. Locate the fl ame generation cylinder drum. It is
attached to the inside of the back plate. They
are 2 matte black sheet metal pieces with holes
in them, either of which can be removed from
the appliance.
C. Remove the screw as illustrated, that is used to
secure the fl ame generation cylinder drum.
D. Squeeze half of drum cylinder until its top edge
clears the top drum track. Remove the bottom
edge of the cylinder drum from the bottom drum
track. This will give you access to the light bulbs.
NOTE: Do not exert excessive pressures on
the drum cylinder as this may cause damage.
E. Remove spring clip. Hold socket and pull out old
bulb.
F. Hold socket and push in new bulb (DO NOT
exceed wattage). Reattach spring clip.
G. Repeat steps 5 and 6 for the remaining bulbs if
necessary.
H. Replace the back plate by reattaching the 6
screws that were removed from step A.
4 Bulbs with
Spring Clips
Flame Generation
Cylinder Drum
Drum Bulb Replacement
[a]
[b]
Flame Generation Bulb Location
Flame Generation Bulb Location
screw
Back View
Flame Generation
Cylinder Drum
6 screws
Back View
!
WARNING
REMOVE THE APPLIANCE FROM THE WALL AND TURN OFF ELECTRICAL POWER BEFORE
SERVICING THE APPLIANCE.