Napoleon Fireplaces EF39HD - Manuel (Page 9)

9
W415-0752 / D / 02.03.12
Due to the many different materials used on different walls, it is highly recommended that you consult your
local builder before you install this appliance on the wall.
A. Select a location that is not prone to moisture and is located
at least 36" away from combustible materials such as curtain
drapes, furniture, bedding, paper, etc.
B. Have two people hold the appliance against the wall to
determine the fi nal location.
C. With the appliance in position and level measure from the
fl oor to the top back edge as illustrated.
D. The supplied wall mount bracket will be centered on the back
of the appliance. This bracket has four slots and three hooks
on it. The top slots will be located 1.250” down
from the previously measured top back edge.
The bottom slots will be 2.250” down from this
edge.
E. Mark out location, then mount the bracket onto
the wall using the four supplied screws. Ensure
the top slots measurement from the fl oor is
1.250” lower then the top back edge measured
earlier. This bracket MUST have the hooks
facing upward and be level. NOTE: It is strongly
recommended that the mounting bracket be
screwed into the wall studs where possible.
If the wall studs cannot be used, ensure that the supplied plastic anchors are used to affi x the
bracket to the wall and the bracket is adequately secured.
F. With the wall mounting bracket installed have two people lift the
appliance up and insert the three hooks on the bracket into the
three slots on the back of the appliance.
G. Check the appliance for stability ensuring that the bracket will not
pull free from the wall, causing the appliance to fall.
3.1.3 INSTALLING THE APPLIANCE
Side View
19.750” MIN
Body
Floor
26.500”
46.250”
MIN
Glass Front
Screws
Hooks
Wall Mount
Bracket
Back View
Slots