Sony ACC-TRDCX - Manuel

BC-DCX
Thank you for purchasing the Sony charger.
Before operating this charger, please read this manual thoroughly
and retain it for future reference.
Owner’s Record
The model and serial numbers are located on the bottom. Record
the serial number in the space provided below. Refer to these
numbers whenever you call upon your Sony dealer regarding this
product.
Model No. BC-DCX Serial No.
WARNING
To reduce fire or shock hazard, do not expose the unit to rain or
moisture.
Do not expose the batteries to excessive heat such as sunshine, fire
or the like.
Battery to be recharged for this product is follows
Brand Name Sony
Battery Type NP-BX1
Rating DC 3.6 V
4.5 Wh (1,240 mAh)
NOTICE FOR THE CUSTOMERS IN THE U.S.A.
CAUTION
You are cautioned that any changes or modifications not expressly
approved in this manual could void your authority to operate this
equipment.
NOTE
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for
help.
This device complies with Part 15 of the FCC rules. Operation is
subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
The shielded USB cable must be used with the equipment in order
to comply with the limits for a digital device pursuant to Subpart B
of Part 15 of FCC Rules.
Notes on Use
This unit does not have dust-proof, splash-proof or water-
proof specifications.
Warranty for Recorded Content
Contents of the recording cannot be compensated if recording or
playback is not made due to a malfunction of the battery pack,
charger, etc.
Where not to place this unit
Do not place this unit in any of the following locations, whether it is
in use or in storage. Doing so may lead to a malfunction.
 In direct sunlight such as on dashboards or near heating
apparatus, as this unit may become deformed or malfunction
 Where there is excessive vibration
 Where there is strong electromagnetism or radiant rays
 Where there is excessive sand
In locations such as the seashore and other sandy areas or where
dust clouds occur, protect this unit from sand and dust. There is
a risk of malfunction.
Precautions on Use
 Attach the battery pack firmly to this unit when charging the
battery pack.
 Do not drop or apply mechanical shock to this unit.
 Keep this unit away from TVs or AM receivers.
Noise from this unit may enter a TV or radio if placed nearby.
 Be sure that nothing metallic comes into contact with the metal
parts of this unit. If it does, a short may occur and this unit may
be damaged.
 The battery pack and this unit can become warm during or
immediately after recharging.
Maintenance
 If this unit gets dirty, wipe it using a soft dry cloth.
 If this unit gets very dirty, wipe it using a cloth with a little
neutral solvent added, and then wipe it dry.
 Do not use thinners, benzine, alcohol, etc., as they will damage
the surface of this unit.
 When you use a chemical cleaning cloth, refer to its instruction
manual.
 Using a volatile solvent such as an insecticide or keeping this unit
in contact with a rubber or vinyl product for a long time may
cause deterioration or damage to this unit.
To Charge the Battery Pack
Make sure to attach the battery pack to the charger before
connecting a micro USB cable.
1
Attach the battery pack to the charger.
Slide the top cover of the charger to open.
Keeping the battery mark  in the same direction as the
charger mark , insert the battery pack into the charger until
it clicks into place.
Slide the top cover of the charger in the reverse direction to
close. (See illustration )
2
Connect a micro USB cable (not supplied) to this
unit, and then to the USB charging device (PC,
USB AC charger). (See illustration )
The CHARGE lamp (orange) lights up and charging begins.
When the CHARGE lamp goes out, charging is completed.
To remove the battery pack
Disconnect the micro USB cable from this unit, and then slide the
top cover of the charger to open.
Lightly push the battery pack in the direction of its mark , lift the
end of the battery pack to release it from the charger’s clamp, then
slide the battery pack from the charger.
Slide the top cover of the charger in the reverse direction to close.
Tip
The travel DC charger (BC-DCX) also can be used as a protected
case when carrying the battery.
Charging time
Battery pack NP-BX1
Full charging time
(Approx.)
155 min (Using AC-UD10, AC-UD11)
230 min (Using PC, AC-UB10)
 For more about the battery life, see the instruction manual of
your camera.
 The charging time may differ depending on the condition of the
battery pack or the ambient temperature.
 The times shown are for charging an empty battery pack, which
has been run down with a camera, using this unit at an ambient
temperature of 25 °C (77 °F).
Charging temperature
The temperature range for charging is 0 °C to 40 °C (32 °F to
104 °F).
For maximum battery efficiency, the recommended temperature
range when charging is 10 °C to 30 °C (50 °F to 86 °F).
To use the battery pack quickly
You can remove the battery pack from this unit and use it even if
charging is not completed. However, the charging time affects the
time that the battery pack can be used.
Notes
 If the CHARGE lamp does not light up, check if the battery pack
is firmly attached to this unit, and then disconnect and reconnect
the micro USB cable.
 When a fully charged battery pack is installed, the CHARGE
lamp lights up once and then goes out.
 A battery pack that has not been used for a long time may take
longer than usual to charge.
 The charged battery pack gradually discharges even if you do not
use it. Charge the battery pack before use to avoid missing any
recording opportunities.
Troubleshooting
The CHARGE lamp (orange) does not light up
 The battery is fully charged.
 Make sure a micro USB cable (not supplied) is connected to this
unit and the USB charging device firmly.
 Connect this unit directly to the PC, not via a USB hub, etc.
 If the room temperature is out of the appropriate temperature
range, charging stops automatically.
When the room temperature returns to the appropriate range, the
CHARGE lamp lights up and charging restarts.
We recommend charging the battery pack at 10 °C to 30 °C
(50 °F to 86 °F).
Specifications
Input rating DC 5 V
Output rating Battery charge terminal:
DC 4.2 V 0.86 A
Operating temperature 0 °C to 40 °C (32 °F to 104 °F)
Storage temperature –20 °C to +60 °C (–4 °F to +140 °F)
Dimensions (Approx.) 36 mm × 70 mm × 13.5 mm (w/h/d)
(1 7/16 in. × 2 7/8 in. × 9/16 in.)
Mass Approx. 17 g (0.6 oz)
Design and specifications are subject to change without notice.


USB charging device
(PC, USB AC charger)
Charger
Battery pack
Charger  mark
Battery  mark
Micro USB cable
(not supplied)
CHARGE lamp
English
The ACC-TRDCX comes with the following accessories:
ACC-TRDCX
Rechargeable Battery Pack (NP-BX1) (1)
Travel DC charger (BC-DCX) (1)
Set of printed documentation
NP-BX1
Specifications
Maximum output voltage: DC 4.2 V / Nominal output voltage:
DC 3.6 V / Capacity: 4.5 Wh (1,240 mAh) / Operating temperature:
0 °C to 40 °C (32 °F to 104 °F) / Dimensions: Approx. 29.9 mm ×
9.2 mm × 42.7 mm (w/h/d) (1 3/16 in. × 3/8 in. × 1 11/16 in.) /
Mass: Approx. 25 g (0.9 oz.)
4-469-980-11(2)
Accessory Kit
Kit d’accessoires
Operating Instructions
Mode d’emploi
ACC-TRDCX
©2013 Sony Corporation Printed in China