Sony HT-ST7 - Manuel (Page 17)

17
HT-ST7 4-463-413-12(1)
Adjusting the settings / Configuration des réglages
Press MENU on the remote control, then select the desired setting using  /  /ENTER/RETURN.
Menu Function Default
LEVEL
DRC
(DYNAMIC RANGE
CONTROL)
You can enjoy Dolby Digital sound at low sound volumes. (ON/AUTO/OFF)
ON: Compresses sound in accordance with the compression information
contained in the content.
AUTO: Automatically compresses sound encoded in Dolby TrueHD.
AUTO
AUDIO
SYNC
(AV SYNC)
You can adjust the sound when the image and the sound are not in sync. (1 – 4/
OFF)
OFF
DUAL
(DUAL MONO)
You can enjoy multiplex broadcast sound of Dolby Digital audio. (M/S (main and
sub channels)/MAIN (main channel)/SUB (sub channel))
MAIN
S. OPT
(SOUND OPTIMIZER)
Adjusts the sound so that it is reproduced dynamically and more clearly even at
low sound volumes. (ON/OFF)
OFF
HEQ
(HARMONICS EQUALIZER)
Reproduces the very low volume sounds that tend to be eliminated by audio
compression. (ON/OFF)
Note: HEQ functions only when “BT AU” is selected. This does not function with
any other inputs, even though the item is displayed on the front panel.
ON
AAV
(ADVANCED AUTO
VOLUME)
Reduces the volume discrepancies between different programs or between
programs and commercials. (ON/OFF)
OFF
HDMI
CTRL
(CONTROL FOR HDMI)
Switches the Control for HDMI function on or off. (ON/OFF) ON
P. THRU
(PASS THROUGH)
Sets the power saving mode of the pass-through function of HDMI signals.
(AUTO/ON)
AUTO: Outputs signals from the HDMI OUT TV (ARC) jack of the system in
standby mode when the TV is turned on. This setting saves power in
standby mode compared with the “ON” setting.
ON: Always outputs signals from the HDMI OUT TV (ARC) jack in standby mode.
Note: This item appears only when “CTRL (CONTROL FOR HDMI)” is set to “ON.”
AUTO
ARC
(AUDIO RETURN
CHANNEL)
Allows you to listen to digital sound from a TV compatible with the Audio Return
Channel (ARC) technology is connected using an HDMI cable. (ON/OFF)
Note: This item appears only when “CTRL (CONTROL FOR HDMI)” is set to “ON.”
ON
SET BT
BT.STBY
(BLUETOOTH STANDBY)
When the system has pairing information, the system is in BLUETOOTH standby
mode even when it is turned off. (ON/OFF)
Note: During BLUETOOTH standby mode, the BLUETOOTH indicator flashes in
blue slowly.
OFF
AAC
(ADVANCED AUDIO
CODING)
Sets whether or not the system will use AAC via BLUETOOTH. (ON/OFF)
Note: If you change the setting when the system is connected with a
BLUETOOTH device, the system will be disconnected from the device.
OFF
MENU
 / 
ENTER
RETURN