Troubleshooting, Specifications – Sony SCD-C222ES Manuel d'utilisation

Page 29

Advertising
background image

29

US

Additional Information

Troubleshooting

If you experience any of the following difficulties while
using the player, use this troubleshooting guide to help
you remedy the problem. Should any problem persist,
consult your nearest Sony dealer.

There is no sound.

, Check that the player is connected securely.
, Make sure you operate the amplifier correctly.
, When you use the headphones, adjust the volume

with PHONES LEVEL.

There is no sound from the DIGITAL (CD) OUT
connector.

, The audio signals of the super audio CD cannot be

output from the DIGITAL (CD) OUT connector.

The disc does not play.

, There is no disc inside the player.
, Place the disc on the disc tray with the label side

up.

, The disc is placed at an angle. Reload the disc.
, Clean the disc (page 28).
, Moisture has condensed inside the player. Remove

the disc and leave the player turned on for about
an hour.

, There is an incompatible disc on the tray (page 11).

The remote does not function.

, Remove any obstacles in the path of the remote

and the player.

, Point the remote at the remote sensor on the

player.

, If the batteries in the remote are weak, replace

with new ones.

, Be sure that the command mode of the remote

(position of the CD 1/2 switch, page 9) mutches
the command mode of the player (page 6).

There is no sound from the SUB WOOFER jack.

, Select the playback mode so that the Sub woofer is

set to “a” (page 21).

, When you play a track that does not contain the

LFE signal, the signal outputs from the SUB
WOOFER jack only when you select “5 – Small +
SW” or “FRT – Large + SW” for the Multi-channel
playback mode (page 22).

Specifications

When a super audio CD is played

Playing frequency range

2 Hz to 100 kHz

Frequency response

2 Hz to 50 kHz (–3 dB)

Dynamic range

104 dB or more

Total harmonic distortion rate

0.0018 % or less

Wow and flutter

Value of measurable limit (±0.001 %
W. PEAK) or less

When a CD is played

Frequency response

2 Hz to 20 kHz

Dynamic range

99 dB or more

Total harmonic distortion rate

0.0020 % or less

Wow and flutter

Value of measurable limit (±0.001 %
W. PEAK) or less

Output connector

General

Laser

Semiconductor laser
(SACD:

λ

= 650 nm)

(CD:

λ

= 780 nm)

Emission duration: continuous

Power requirements

120 V AC, 60 Hz

Power consumption

26 W

Dimensions (w/h/d)

430

Ч

135

Ч

400 mm

(17

Ч

4 1/4

Ч

15 3/4 in.)

incl. projecting parts

Mass (approx.)

7.5 kg (16 lbs 9 oz.)

Supplied accessories

See page 4.

Design and specifications are subject to change without notice.

Jack type

Output level

Load impedance

ANALOG OUT Phono

2 Vrms

Over 10 kilohms

jacks

(at 50 kilohms)

DIGITAL (CD)

Square

–18 dBm

OUT OPTICAL* optical

output
connector

DIGITAL (CD)

Coaxial

0.5 Vp-p

75 ohms

OUT COAXIAL* output

connector

PHONES

Stereo

10 mW

32 ohms

phone jack

*Output only the audio signals of the CD

Light emitting
wave length:
660 nm

( )

Advertising