Sony PCV-RX672 - Manuel (Page 4)

4
SAFETY INFORMATION AND CAUTION
Your computer’s installed optical drives may vary,
depending on the system configuration you have
purchased. See the Specifications sheet for details
on your installed optical drives.
DVD-RW Laser Diode Properties
DVD-ROM Laser Diode Properties
CD-RW Laser Diode Properties
CD-ROM Laser Diode Properties
❑
To prevent fire or shock hazard, do not expose
your desktop to rain or moisture. To avoid
electrical shock, do not open the cabinet.
Refer servicing to qualified personnel only.
❑
Never install modem or telephone wiring
during a lightning storm.
❑
Never install telephone jacks in wet locations
unless the jack is specifically designed for
wet locations.
❑
Never touch uninsulated telephone wire or
terminals unless the telephone line has been
disconnected at the network interface.
❑
Use caution when installing or modifying
telephone lines.
❑
Avoid using the modem during an electrical
storm.
❑
Do not use the modem or a telephone to
report a gas leak in the vicinity of the leak.
❑
The socket outlet shall be installed near the
equipment and shall be easily accessible.
Laser Output 1.3 mW
(CD-Read)
1.1 mW
(DVD-Read)
42.3 mW
(DVD-Write)
21.9 mW
(CD-Write)
Wave Length 650-662 nm
(DVD)
773-797 nm
(CD)
Laser Output 0.5 mW (DVD)
0.39 mW (CD)
Wave Length 635-665 nm
(DVD)
770-810 nm
(CD)
Laser Output 2.0 mW (Read)
53.0 mW (Write)
Wave Length 7 78-790 nm
Laser Output 0.2 mW
Wave Length 760-810 nm
To change the backup battery, please
contact your nearest Sony Service
Center.
Caution: The use of optical instruments
with this product will increase eye
hazard. As the laser beam used in this
product is harmful to the eyes, do not
attempt to disassemble the drive
cabinet. Refer servicing to qualified
personnel only.
Danger: Visible and invisible laser
radiation when open. Avoid direct
exposure to beam.
For CD-RW: Danger—Visible and
invisible laser radiation when open.
Avoid direct exposure to beam.
For DVD-RW: Danger—Visible laser
radiation when open. Avoid direct
exposure to beam.
Caution: For ADSL, HomePNA and V.90
modem models; to reduce the risk of fire,
use only No. 26 AWG or larger
telecommunication line cord.