Specifications, Troubleshooting, Additional information – Sony PS-LX250H Manuel d'utilisation

Page 7

Advertising
background image

7

GB

Specifications

Motor and Platter
Drive system

Belt-drive

Motor

DC motor

Platter

295 mm dia. (aluminum, die-cast)

Speeds

33

1

/

3

and 45 r/min, 2 speed

Wow and flutter

Less than 0.25% (WRMS)

Signal to noise ratio

More than 50 dB (DIN-B)

Tone Arm
Type

Dynamic balanced straight shaped with
soft damping control

Effective arm length

195 mm

General
Power requirements

U.S.A. and Canada: 120 V AC, 60 Hz
European countries: 230 V, 50/60 Hz

Power consumption

2 W

Dimensions

Approx. 420 x 100 x 342 mm (w/h/d)

Mass

2.7 kg

Supplied Accessories
45 r/min adaptor (1)
Platter (with drive belt) (1)
Rubber mat (1)
Dust cover (1)

Design and specifications are subject to change without notice.

Troubleshooting

Before going through the check list below, first make
sure that:
• The power cord is securely connected.
• The speaker cords are securely connected.
Should any problem persist after you have made these
checks, consult your nearest Sony dealer.

The tone arm skips, skates or does not advance.

b The turntable is not level. Place the turntable on a

level surface.

b The record is dirty or scratched.

Clean the record with a commercially available
record cleaning kit, or replace the record.

Poor sound quality, excessive noise, intermittent sound,
etc…

b The stylus is dirty or worn. Remove dust on the

stylus using a stylus cleaning brush, or replace the
worn stylus (see page 6).

b Dust or dirt has collected on the record. Clean the

record using a good quality record cleaner.

Rumble or low-frequency howl*.

b The turntable is placed too close to speakers. Move

speakers away from the turntable.

Tempo is incorrect.

b Incorrect r/min. Set the r/min setting to match the

one indicated on the record. (Select “33” for 33

1

/

3

r/min records or “45” for 45 r/min records.)

The drive belt is deteriorated.

b Replace the drive belt. For details, please make a

contact with Sony dealer.

Platter does not rotate.

b Make sure the power cord is inserted all the way into

an AC wall outlet.

The drive belt is broken.

b Replace the drive belt. For details, please make a

contact with Sony dealer.

Sound is too low or distorted.

b The turntable is not connected to the PHONO IN

inputs on the amplifier (see page 4).

* This phenomenon, called “acoustic feedback”, occurs

when vibrations from the speakers are transmitted
through the air or via solid objects (such as shelves, a
cabinet, or the floor) to the turntable where they are
picked up by the stylus, amplified and reproduced
through the speakers.

Additional Information

Advertising