Installation requirements, Warning, Tools and parts – Whirlpool W10477533B Manuel d'utilisation

Page 3

Advertising
background image

3

INSTALLATION REQUIREMENTS

Tools and Parts

Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed here.

Tools needed

Parts supplied

Check that all parts are included.

Literature bag

Conversion orifice spuds (inside bag containing literature)

Anti-tip bracket must be securely mounted to floor or wall.
Thickness of flooring may require longer screws to anchor
bracket to floor.

Parts needed

Check local codes and consult gas supplier. Check existing gas
supply and electrical supply. See “Electrical Requirements” and
“Gas Supply Requirements” sections.

In the State of Massachusetts, the following installation instructions apply:

Installations and repairs must be performed by a qualified or licensed contractor, plumber, or gasfitter qualified or licensed by

the State of Massachusetts.

If using a ball valve, it shall be a T-handle type.

A flexible gas connector, when used, must not exceed 3 feet.

Tip Over Hazard

A child or adult can tip the range and be killed.

Install anti-tip bracket to floor or wall per installation instructions.

Slide range back so rear range foot is engaged in the slot of the anti-tip bracket.

Re-engage anti-tip bracket if range is moved.

Do not operate range without anti-tip bracket installed and engaged.

Failure to follow these instructions can result in death or serious burns to children and adults.

Anti-Tip
Bracket

To verify the anti-tip bracket is installed and engaged:

Slide range forward.

Look for the anti-tip bracket securely attached to floor or wall.

Slide range back so rear range foot is under anti-tip bracket.

See installation instructions for details.

Range Foot

WARNING

Tape measure

Flat-blade screwdriver

Phillips screwdriver

Level

Hand or electric drill

Hammer

Wrench or pliers

Pipe wrench

¹⁵⁄₁₆" combination wrench

¼" drive ratchet

³⁄₈" nut driver

¹⁄₈" (3.2 mm) drill bit (for

wood floors)

Marker or pencil

Pipe-joint compound
resistant to LP gas

Noncorrosive leak-detection
solution

For LP/Natural Gas
Conversions

³⁄₈" combination wrench

½" combination wrench

⁵⁄₈" combination wrench

7 mm (

⁹⁄₃₂") nut driver

Quadrex

®†

or Phillips

screwdriver

Masking tape

†® QUADREX is a registered trademark of NLW Holdings, Inc.

A. Anti-tip bracket
B. #12 x 1

⁵⁄₈"

screws (2)

A

B

Advertising