Samsung WF218ANW-XAA - Manuel (Page 17)

Maintaining your washer _17
STORING YOUR WASHER
Washers can be damaged if water is not removed from hoses and internal components before storage.
Prepare your Washer for storage as follows:
• Select the Quick Wash cycle and add bleach to the automatic dispenser. Run your Washer through the
cycle without a load.
• Turn the water faucets off and disconnect the inlet hoses.
• Unplug your Washer from the electrical outlet and leave your Washer door open to let air circulate inside
the tumbler.
• If your Washer has been stored in below–freezing temperatures, allow time for any leftover water in your
Washer to thaw out before use.
CLEANING THE DEBRIS FILTER
We recommend cleaning the debris fi lter when water does not drain well or the “ND” error message is
displayed.
1. Open the fi lter cover by pressing and pulling the handle of
the fi lter cover with your fi nger.
2. Unscrew the drain cap by turning it counter-
clockwise.
3. Hold the cap on the end of the drain tube and
slowly pull it out about 6inches (15cm) and
drain off all the water.
4. Remove the debris fi lter cap.
5. Wash any dirt or other material from the
debris fi lter. Make sure the drain pump
propeller behind the debris fi lter is not
blocked.
6. Replace the debris fi lter cap.
7. Replace the fi lter cover
8. Close up the opening of drain tube with cap.
9. Don’t insert the drain tube in the hole
04 Maintaining your washer
Step 1 Step 2
WF218ANS-02440D-07_EN.indd Sec4:17 WF218ANS-02440D-07_EN.indd Sec4:17 2011-06-07 3:13:13 2011-06-07 3:13:13