Samlex America SSP-150-KIT - Manuel (Page 10)

10
4
INSTALLATION OVERVIEW
Warning!
Please read Section 1: General Safety before starting installation.
Block Diagram of Typical RV Installation (Fig 4.1)
NOTE: Solar Charge Controller and battery shown in Fig. 4.1 are shown as part of a typical 12V Solar
Charging System installation. The Charge Controller and battery are not supplied as part of the kit.
1. Read the manual in detail and understand the installation procedure.
2. Open the packaging and check to make sure that all parts have been received as per the List of
Components (page 5).
3. Arrange for the required tools to carry out the installation. A sample list of tools (not exhaustive)
is provided in Section 4.
4. Determine the mounting location of the solar panel(s) on the roof of the RV.
5. Mount the Charge Controller at the desired location (see Section 6).
6. Pass the cable from the solar panels to the interior of the RV (See Section 7).
7. Wire the battery to the Charge Controller through fuse and then the solar panel to the Charge
Controller ensuring correct polarity is observed (See Section 7).
8. Secure the solar panel to the RV roof (See Section 7).
Solar
Panel
Battery
Solar
Charge
Controller
Fuse within 7”
of battery post
Fig. 4.1. Installation Block Diagram