STEINEL RM 50 - Manuel (Page 4)

120/
230/
277 VAC
50/60Hz
Wireless
Voltage
Load rating
Environment
RF
Dimensions
5 year warranty
UL and CUL Listed, RoHS Compliant, FCC and IC Compliant
120/230/277 VAC, 50/60 Hz
120 VAC: 0-800 watt ballast or Tungsten - 1/4 hp
230/277 VAC: 0-1200 watt ballast
IP20 rated, -4°F to +122°F, -20°C to +50°C
see page 3
3.92 x 3.92 x 1.56 in, 99.6 x 99.6 x 39.6 mm
nipple length .62 in (15.75 mm)
Specifi cations
1/2 inch threaded nipple
Lock nuts
Group address DIP switch
1
2
3
IP20
Fixture
or J Box
Mount
3
Product Overview RM 50
Product description
The RM 50 Wireless Receiver works with
STEINEL wireless sensors to extend group
lighting control without adding additional
sensors. It turns lighting on and off based on
detection from a wireless occupancy sensor
programmed to the same group.
The RM 50 mounts to a 1/2 inch knockout of
a lighting fi xture or junction box. The wireless
devices are grouped together via a DIP switch
address. Any wireless occupancy sensor will
switch all devices in a group ON when triggered.
ON
DIP
12
3 4 5
2
1
Mounting
• Receiver module mounts to a 1/2” knockout
of a lighting fi xture or junction box.
• Module must not be mounted within a metal
enclosure.
• Module can be mounted at any height and
is not affected by heating/cooling supply
ducts.
End of fi xture mounting -
RHB 300, RHB 200 End of fi xture mounting - RM 50
Placement guidelines -
RHB 300, RHB 200 Placement guidelines - RM 50
The RHB 300 and RHB 200 typically mount to
a 1/2” knockout at the end of a high/low bay
lighting fi xture. The sensor's lens should be
mounted below the bottom edge of the fi xture.
The EM 1 Extender Module is recommended
for use with the RHB 300 and RHB 200 if the
knockout at the end of the fi xture is located
greater than 1/2” from the bottom edge of the
fi xture.
The RM 50 typical mounts to a 1/2” knockout
at the end of a high/low bay lighting fi xture.
The receiver has no lens and therefore can be
mounted to any 1/2” knockout on the fi xture.
EM 1
Fixture
RHB Sensor
RHB Sensor
Fixture
RM 50
Fixture
• Sensor module mounts to a 1/2” knockout
of a lighting fi xture or junction box.
• Detection lens must have a clear,
unobstructed view of controlled area and
must project beyond the lamps.
• Sensor should be 6 to 8 feet away from
heating/cooling supply ducts.
• Ideal mounting height is up to 45 feet.
• Must be mounted on a stable platform.
www.steinel.net (800) 852-4343 www.steinel.net (800) 852-4343
6 7