Electrolux EC4230AOW - Manuel (Page 6)

3.2 Switching on
B
C
A
A) Temperature Regulator
B) Half Loaded position
C) Full Loaded position
1. Insert the plug into the wall socket.
2. Turn the Temperature Regulator to the
Full Loaded position and let the
appliance run for 24 hours to allow the
correct temperature to be reached
before placing food inside.
The pilot light will light up.
3. Adjust the Temperature Regulator
according to the quantity of the stored
foods.
3.3 Switching off
Turn the Temperature regulator to the OFF
position.
3.4 Temperature regulation
The temperature within the appliance is
controlled by the Temperature Regulator
situated on the control panel.
To operate the appliance, proceed as
follows:
• to obtain the minimum coldness, turn
the Temperature Regulator toward
lower settings.
• to obtain the maximum coldness. turn
the Temperature Regulator toward
higher settings.
In case of freezing less food
volumes, the Half Loaded
setting is the most suitable. In
case of freezing much food
volumes, the Full Loaded
setting is the most suitable.
3.5 High temperature alarm
An increase in the temperature in the
freezer (for example due to an power
failure) is indicated by switching on of the
Alarm light
During the alarm phase, don't place food
inside the freezer.
When normal conditions are restored the
Alarm light will switch off automatically.
4. BEFORE FIRST USE
WARNING!
Refer to Safety chapters.
4.1 Cleaning the interior
Before using the appliance for the first
time, the interior and all internal
accessories should be washed with
lukewarm water and some neutral soap to
remove the typical smell of a brand-new
product, then dried thoroughly.
CAUTION!
Do not use detergents or
abrasive powders, as these
will damage the finish.
www.electrolux.com 6