Electrolux EGT6242NOK - Manuel (Page 7)

Symbol Description
minimum gas
supply
4. DAILY USE
WARNING!
Refer to the Safety chapters.
4.1 Ignition of the burner
WARNING!
Be very careful when you use
open fire in kitchen environment.
Manufacturer decline any respon-
sibility in case of misuse of the
flame
Always light the burner before you
put cookware.
Lightning the burner:
1. Push the control knob down and turn
it counterclockwise to the maximum
position (
).
2. Keep the control knob pushed for
equal or less than 10 seconds to let
the thermocouple warm up. If not, the
gas supply will be interrupted.
3. Adjust the flame after it is regular.
If the burner does not light after
some tries, check if the crown and
its cap are in correct positions.
A
B
C
D
A) Burner cap
B) Burner crown
C) Ignition candle
D) Thermocouple
WARNING!
Do not keep the control knob
pushed for more than 15 sec-
onds.
If the burner does not light after
15 seconds, release the control
knob, turn it into off position and
try to light the burner again after
minimum 1 minute.
In the absence of electricity you
can ignite the burner without elec-
trical device; in this case approach
the burner with a flame, push the
relevant knob down and turn it
counter-clockwise to maximum
gas release position.
If the burner accidentally goes out,
turn the control knob to the off
position and try to light the burner
again after minimum 1 minute.
The spark generator can start au-
tomatically when you switch on
the mains, after installation or a
power cut. It is normal.
4.2 Turning the burner off
To put the flame out, turn the knob to the
symbol
.
WARNING!
Always turn the flame down or
switch it off before you remove the
pans from the burner.
ENGLISH 7