Bosch SGV63E03UC - Manuel (Page 13)

11
Delay Start
You can delay the start of the cycle in one hour increments up to 24 hours.
To set delay start:
1
Open the door and press the [On/Off] button.
2
Press the [+] button until the display jumps to “h:01”.
3 Press the [+] or [-] button until the displayed time corresponds with your requirements.
h:01 = 1 hour delay
h:24 = 24 hour delay
4
Press [Start] to activate delay start.
To cancel delay start:
1
Press the [+] or [-] button until “h:00” is indicated on the digital display.
2
Press [Start] to save setting and close the door.
Setting the amount of rinse aid
The amount of rinse aid dispensed can be set from “r:00” to “r:06”.
To change the setting:
1
Open the door and press the [On/Off] button.
2
Hold down the “A” button (see page 4) and press [Start] until the display indicates “H:00”.
3
Release both buttons.
4
Press the “A” button until the display shows “r:05”.
5
Press the “C” button to select the desired setting.
“r:00” = dispenser is OFF
“r:01” = lowest setting
“r:02” = low setting
“r:03” = medium setting
“r:04” = medium/high setting
“r:05” = high setting
“r:06” = highest setting
6
Press [Start] to save the setting and close the door.
Cycle Completion Signal
1
Open the door and press the [On/Off] button.
2
Hold down the “A” button (see page 4) and press [Start] until the display indicates “H:00”.
3
Release both buttons.
4
Press the “A” button until the display shows “b:02”.
5 Press the “C” button to increase or decrease the tone “b:00” = OFF and “b:03” = LOUDEST
6
Press [Start] to save setting and close the door.
Intensive Drying
The final rinse uses a higher temperature which improves the drying results. The running time may
increase slightly.
To turn intensive drying on:
1
Open the door and press the [On/Off] button.
2
Hold down the “A” button (see page 4) and press [Start] until the display indicates “H:00”.
3
Release both buttons.
4 Press the “A” button until the display shows “d:00”.
5
Press the “C” button to turn intensive drying on or off. “d:01” = ON and “d:00” = OFF
6
Press [Start] to save setting and close the door.