Canon MP41DHIII GB - Manuel (Page 3)

Replacing The Ink Ribbon
Note: Turn the power switch off.
1) Lift up the tab on the back-side of the printer cover, and then remove the cover.
(Figure )
2) While pinching together the ribbon lock (A) in the direction of arrow, lift ribbon
spools off the shafts. Discard the old ribbon and spools. (Figure )
3) Separate the spools of new ribbon between the tape and printer head. Guide it
around the four positions of the ribbon guide (B) and place the spools on the
shafts. (Figure )
4) When the ribbon spools have settled, release the ribbon locks. If necessary,
rotate the spools until the pegs on the botton of the spool seat themselves in
the holes of the spool holder. (Figure )
5) Rotate either spool to take up any ribbon slack, making sure that the ribbon is
positioned around the four ribbon guides. Replace the printer cover. (Figure )
IMPORTANT: Use only the same type of ribbon spools.
1) Lift up the paper arm (Figure ).
• When inserting the paper, cut the edge of the paper as shown.
2) Place the new paper roll on the arm. The edge of the paper should be
positioned as shown (Figure ).
• Suitable paper roll – Width: 57mm (2-1/4”) / Diameter: max. 86mm (3-3/8”)
3) Insert the paper into the slit located at the top of the machine as indicated
(Figure ).
4) Turn the power on. Press the paper feed key to advance the paper
(Figure ).
Inserting Printing Paper
FEED
2