Basic frame assembly, Step 1 step 4 step 3 step 2 – ShelterLogic 27272 24 x 30 UltraMax Peak Canopy Manuel d'utilisation

Page 5

Advertising

05-27272-OB

Page 5

800216

800095

800216

800095

800097

Basic Frame Assembly

step 1

step 4

step 3

step 2

Assemble the wind brace set as shown in Figure 1.

Assemble (2) #800216 Corner Support Tubes and (4) # 800095 middle support tube as shown in Fig. 4A and

set aside. Assemble other side Support Tubes as shown in Fig. 4B and connect the middle support tubes with

#800218 (5/16 x 3 in. Bolts) and Nuts. Repeat this step at opposite side.
Note: #800218 Bolts are required for middle support tube connections. Bolts are not inserted to the

corner legs (#800216) at this step.

Use #800097 Cross Rails, #800217

(5/16 x 2 in. Bolts) and Nuts to connect

these ribs. See Fig. 3

See Figure 2A.

Fit together the end rib using the following parts

(1) #800091 3-Way Top Connectors

(2) #800096 Rafter Poles

(2) #800095 Common Tubes

(2) #800092 3-Way Side Connectors

(1) Wind Brace set
Fig 2B:

Fit together the middle rib using the following parts

(1) #800093 4-Way Top Connectors

(2) #800096 Rafter Poles

(2) #800095 Common Tubes

(2) #800094 4-Way Side Connectors

(1) Wind Brace set

Using (6) #800218 (5/16 x 3 in. Bolts) and (8) Nuts

securely fasten these tubes. Lay these ribs on the

ground at the rear of your shelters designated location.

Wind Brace

800091

800093

800096

800095

Wind Brace

Fig. 1

Fig. 3

Fig. 4A

Fig. 4B

Fig. 2A:

2 End Ribs

Fig. 2B:

Middle Ribs

#800217

#00690

#800103

#800104

800092

800094

NOTE: Be sure that all of the heads of the bolts are

facing toward the outside of the rib.

Repeat step 2A/2B for all the other ribs.

Use #800218 Bolt (5/16 x 3 in.)

Advertising