MAX AKHL1250E - Manuel (Page 8)

8
15. CHECK DAMAGED PARTS AND AIR
LEAK
Before further use of the compressor, a
guard or other part which is damaged should
be carefully checked to determine that it will
operate properly and perform its intended
function.
Check for alignment of moving parts, binding
of moving parts, breakage of parts, mount-
ing, air leak, and any other conditions that
may affected its operation.
A guard or other part that is damaged should
be properly repaired or replaced by an au-
thorized service facility unless otherwise in-
dicated elsewhere in this Instruction Manual.
Have defective pressure controllers re-
placed by authorized service facility.
Do not use compressor if switch does not
turn it on and off.
16. OPERATE COMPRESSOR CORRECTLY
Operate the compressor according to the in-
structions provided herein. Never allow the
compressor to be operated by children, indi-
viduals unfamiliar with its operation or unau-
thorized personal.
17. KEEP ALL SCREWS, BOLTS AND COV-
ERS TIGHTLY IN PLACE
Keep all screws, bolts, and plates tightly
mounted.
Check their conditions periodically.
18. KEEP MOTOR AIR VENT CLEAN
The motor air vent must be kept clean so that
air can freely flow at all times. Check for dust
build-up frequently.
19. OPERATE COMPRESSOR AT THE RAT-
ED VOLTAGE
Operate the compressor at voltages speci-
fied on their nameplates. If using the com-
pressor at a higher voltage than the rated
voltage, it will result in abnormally fast motor
revolution and may damage the unit and
burn out the motor.
20. NEVER USE A COMPRESSOR WHICH IS
DEFECTIVE OR OPERATING ABNOR-
MALLY
If the compressor appears to be operating
unusually, making strange noises, or other-
wise appears defective, stop using it imme-
diately and arrange for repairs by an
authorized service facility.
21. DO NOT WIPE PLASTIC PARTS WITH
SOLVENT
Solvent such as gasoline, thinner, benzine,
carbon tetrachloride, and alcohol may dam-
age and crack plastic parts. Do not wipe
them with such solvents. Wipe plastic parts
with a soft cloth lightly dampened with mild
detergent and dry thoroughly.
22. USE ONLY GENUINE REPLACEMENT
PARTS
Replacement parts not original may void
your warranty and can lead to malfunction
and resulting injuries. Genuine parts are
available from your dealer.
23. DO NOT MODIFY THE COMPRESSOR
Do not modify the compressor. Always con-
tact the authorized service facility any re-
pairs. Unauthorized modification may not
only impair the compressor performance but
may also result in accident or injury to repair
personnel who do not have the required
knowledge and technical expertise to per-
form the repair operations correctly.
24. TURN OFF THE SWITCH WHEN THE
COMPRESSOR IS NOT USED
When the compressor is not used, turn the
switch OFF, disconnect the plug from the
power source and open the drain cock to dis-
charge the compressed air from the air tank.
25. NEVER TOUCH THE SURFACE OF THE
HIGH-TEMPERATURE SECTION
In order to prevent a burn, do not touch the
piping, head, cylinder, motor, tank and in-
verter case (lower cover).
26. DO NOT DIRECT AIR STREAM AT BODY
Risk of injury, do not direct compressed air at
persons or animals.
27. DRAIN TANK
Drain tank daily or after 4 hours of use.