Warning, 3 reconnect air supply, 1 disconnect the air hose – MAX NF665/15 Manuel d'utilisation
Page 11: 2 remove the set of nails from the magazine, 5 close the driver guide a and the latch cover
11
ALWAYS-disconnect air supply before adjusting adjustment
dial.
1
If an adjustment is required, disconnect air supply.
2
Refer to the figure for direction to turn the dial.
3
Reconnect air supply.
THE CONTACT TIP
ALWAYS-disconnect air supply before setting the contact tip.
Set the contact tip on the top of the contact arm, when driving
nails to a soft material.
Use the contact tip at the back of the rear side of the magazine
as necessary.
CLEARING JAMMED NAILS
ALWAYS-disconnect air supply before clearing jammed nails.
1
Disconnect the air hose.
2
Remove the set of nails from the magazine.
3
Open the Latch Cover, then pull up to open the Driver Guide
A.
4
Clear the nails-jammed inside the driver guide using a thin
iron bar or a flat-blade screw driver.
5
Close the Driver Guide A and the Latch Cover.
WARNING
Contact tip
Contact tip
WARNING
Latch Cover
Driver Guide A
WARNING