Kolpin 85110 – Can Am 2 Receiver Hitch - Manuel (Page 2)

Rev. 2
Mounting Specific Instructions:
1. Remove the bolt as shown in the picture. The bolt holds the Aluminum Battery Plate to the frame
and the rear differential.
2. Now, place the Kolpin Can Am 2” Receiver Hitch over the existing hitch plate and line up the
hole where you just removed the bolt.
3. Replace the OEM bolt as shown below. Do not tighten yet.
5. Bolt the Kolpin Can Am Hitch through the OEM hitch using the 3/8” Hex Head Bolts (4x), 3/8”
Washers (8x) and the 3/8” Nylock Nut (4x). . Below is how the final attachment should look on both
the right and left side.
Place Hitch over existing OEM hitch and
align top holes as show. Insert OEM Bolt Back through to attach hitch.
Kolpin Outdoors, Inc.
205 N. Depot Street, Fox Lake, WI 53933
Phone #: (877) 9KOLPIN or (920) 928-6514
www.kolpinpowersports.com
[email protected]