Audiovox FPE2006 - Manuel (Page 30)

Before calling for repair service, check the following items for possible remedies to the
Symptoms Check item
! This may be caused by obstruction to the antenna due to high
rise buildings or hills. Using a highly directional antenna may
“Ghost” or double images
! Check that the AC power cord is plugged into the mains
socket.
! Unplug the power cord, wait for 60 seconds. Then re-insert
No power
! Check antenna connections at the rear of the unit to see if it
is properly connected to the unit.
! Possible broadcast station trouble. Try another channel.
! Adjust the contrast and brightness settings.
! Check the Closed Captions control. Some TEXT modes could
block the screen.
! Select a correct input.
! Is a non-compatible signal being input?
No picture
! Increase the VOLUME.
! Check that the unit is not muted.
Good picture but no sound
• Adjust the contrast, color and brightness Good sound but poor color
! Sometimes, poor picture quality occurs when having
activated an S-VHS camera or camcorder connected and
having connected another peripheral at the same time. In this
case, switch off one of the other peripherals.
Poor picture
! Check the antenna connection.
! This may be caused by electrical interference (e.g. hairdryer,
nearby neon lights, etc.).
! Turn off the equipment.
! Check whether the batteries are working. Replace if
necessary.
! Clean the remote control sensor lens on the unit.
! Do not use the remote control under strong or fluorescent
Snowy picture and noise
Horizontal dotted line
Television not responding to
remote control
! Check if you have selected the correct D-Sub mode in your
No stable or not
synchronized D-Sub picture
If your problem is not solved, turn your unit off and then on again once.
Never attempt to repair a defective unit yourself.
Note:
No output from one
of the speakers
! Adjust Balance in the SOUND menu.
Troubleshooting
28
+ Do not use in hot or cold rooms (locations)
• When the unit is used in rooms (locations) with low temperature, the picture may leave trails or
appear slightly delayed. This is not a malfunction, and the unit will recover when the
temperature returns to normal.
• Do not leave the unit in a hot or cold location. Also, do not leave the unit in a location exposed
to direct sunlight or near a heater, as this may cause the cabinet to deform and the LCD panel to
Control buttons do not work
! Unplug the power cord, wait for some seconds. Then re-plug
the power cord and turn on the unit again.