Velleman AM900 - Manuel (Page 2)

- 2 -
OPERATING MANUAL AM900 AND AM900/5
POWER DOOR LOCK MOTORS
INSTALLATION OF THE ACTUATORS
1. Start the conversion by removing the handles, fittings, the arm rest and the door panel.
Carefully remove the transparent PVC protective sheet under the door panel.
2. Locate an acceptable position parallel to the door lock shaft which will allow the
actuator to operate smoothly, with no interference to the window mechanism (see
drawing 1).
3. Place the connector rod through the hole in the actuator plunger.
4. Insert the connector rods and door lock shaft into the connecting rod adapter and then
secure by inserting the screw, on the two threaded holes of connecting rod adapter
(see drawing 2). Bend the rods slightly (4x6mm) if required for smooth parallel
operation.
5. After selecting the ideal position in steps 2 and 4, then decide whether to install directly
onto the door frame, or install with the mounting bracket (see drawing 3). If install with
the mounting bracket, then fasten the lock washers with screws (4x20mm) onto the
door frame through the mounting bracket.
6. With the actuator and the door latch both in the "down" or "locked" position, adjust the
stop-blocks. Be sure that the window mechanism does not interfere with the actuator
mechanism.
WIRING
Put the actuator on lock position after installing of actuator, then wiring as following.
Black wire : Micro switch "C" (only for AM900/5)
White wire : Micro switch "N/O" (only for AM900/5)
Brown wire : Micro switch "N/C" (only for AM900/5)
Green wire : Motor wire "-"
Blue wire :
Motor wire "+"
Note : Don't put the power "IN" over 1 second, it may damage the unit.