JVC KS-AX6801 - Manuel (Page 2)

2
Subwoofer system
2-subwoofer system (2 amplifi ers)
2-subwoofer system
4-speaker system plus subwoofer—5.1-channel (3 amplifi ers)
Connection varies depending on the number of the speakers used in your car. Select the
appropriate connection referring to the following diagrams.
Before connecting: Securely connect all the parts. If the connections are loose, due to contact
resistance etc., heat will break out and may cause an accident. Secure and cover the cords with
insulating tape and run them under the car mats.
* 1 Not provided for this unit.
* 2 Be sure to connect the both leads to the target speaker lead.
* 3 Be sure to connect the line output from the receiver to the left (L) jack on this unit.
SPEAKER CONNECTIONS
å When your receiver is equipped with Line Output, connect the Line Output (through the
receiver) to the INPUT jacks on this unit.
∫ When your receiver is NOT equipped with Line Output, connect the provided speaker
input connector (through the receiver) to the HIGH INPUT terminal on this unit.
Note
Use the subwoofers with an impedance of 2
Ω to 8 Ω for KS-AX6801 or 4 Ω to 8 Ω for
KS-AX5801.
JVC power amplifi er, etc.
(purchased separately)
JVC power amplifi er, etc.
(purchased separately)
Subwoofer
Subwoofer
Subwoofer
Subwoofer
Subwoofer Subwoofer
Line Out
(Center)
Center Speaker
Note
Use the subwoofers with an impedance of 1
Ω to 8 Ω for KS-AX6801 or 2 Ω to 8 Ω for
KS-AX5801.
A Mount RM-RK130 on a fi rm surface, such as under the dashboard.
B Connect RM-RK130 to the REMOTE terminal on the amplifi er with the Remote Cord
provided for RM-RK130.
C The BASS BOOST controller boosts the 45 Hz frequency within the range of 0 dB to 18
dB. Adjust the level while listening to the sound.
• The POWER lamp lights in green while RM-RK130 is turned on.
Wired remote control unit: RM-RK130 (purchased separately)
Using JVC’s wired remote control unit: RM-RK130 (purchased separately), you can adjust the
bass boost in your seat without adjusting the BASS BOOST controller on the amplifi er (see
"CONTROLS" on page 3) .
Note
Set the BASS BOOST controller on the amplifi er to MIN when you use RM-RK130.
Screw ( φ 4 × 12 mm)
(provided for RM-RK130)
Remote Cord
(provided for RM-RK130)
Drilled hole
Under the dashboard, etc.
RM-RK130
POWER lamp
BASS BOOST
controller
A B C
Note
Incoming signals are emitted through the PRE OUT jacks.
Subwoofer Out
EN_KS-AX6801_5801[EU].indd 2 EN_KS-AX6801_5801[EU].indd 2 07.2.22 2:08:10 PM 07.2.22 2:08:10 PM