Installing the unit on a left-hand- drive car, Installing the power box (fig. 12) – Pioneer DEH-P90HDD Manuel d'utilisation

Page 3

Advertising
background image

Installing the Unit on a Left-Hand-
Drive Car

Note:

• When the unit is installed on a right-hand-drive

car, the horizontal positions are inverted.

1. Secure inner holder to the inner cir-

cumference of the steering wheel
with belt. (Fig. 15)

• Fit the inner holder to the steering wheel so

that the arrow-marked side faces the driver as
shown below.

Fig. 15

2. Cut the extra portion of the belt at

the center of the inner holder. (Fig.
16)

Fig. 16

3. Install outer holder on the inner

holder and secure with screws. (Fig.
17)

• Tighten the screws with the supplied hexago-

nal wrench.

Fig. 17

4. Install the remote control unit in the

holder. (Fig. 18)

• When removing the remote control unit from

the holder, move the corrugated release sec-
tion toward the steering wheel and slide the
remote control unit toward you.

Fig. 18

WARNING

• Avoid installing this unit in such a location where

the operation of safety devices such as airbags is
prevented by this unit. Otherwise, there is a danger
of a fatal accident.

• Avoid installing this unit in such a location where

the operation of the steering wheel and the
gearshift lever may be prevented. Otherwise, it
may result in a traffic accident.

CAUTION

• Installation of this unit requires specialized skills

and experience. Installation of this unit should be
entrusted to a dealer from whom you purchased
this unit.

• Install this unit using only the parts supplied with

this unit. If other parts are used, this unit may be
damaged or could dismount itself, which leads to
an accident or trouble.

• Install this unit as required by this manual. Failure

to do so may cause an accident.

• Do not install this unit near the doors where rain-

water is likely to be spilled on the unit. Incursion
of water into the unit may cause smoke or fire.

WARNING

• Fix this unit securely to the steering wheel with the

belt attached to the unit. If this unit is loose, it dis-
turbs driving stability, which may result in a traffic
accident.

• Do not attach this unit to the outer circumference

of the steering wheel. Otherwise, it disturbs dri-
ving stability, causing a traffic accident. Always
attach this unit to the inner circumference of the
steering wheel as shown. (Fig. 14)

Note:

• Do not install this unit in such a place as may

obstruct the driver’s view.

• Since interior layout differs depending on the type

of vehicle, the ideal installation location for the
unit also differs. When installing the unit, select a
location that assures optimum transmission of sig-
nals from the unit to the car stereo.

Fig. 14

Belt

Inner holder

Screw

Outer holder

Release Section

Installing the Steering Remote Control Unit

<ENGLISH>

Installation

<ENGLISH>

Installing the power box (Fig. 12)

The power box has velcro tape on the underside to secure it to the car mat.

• Wipe the surface thoroughly before affixing the velcro tape.

Fig. 12

About the fixing screws for the front panel (Fig. 13)

If you do not operate the Detaching and Replacing the Front Panel Function, use the sup-
plied fixing screws and fix the front panel to this unit.

Fig. 13

Velcro tape

Car mat

Fixing screw

Advertising