Zanussi Washing Machine ZWH 6145 - Manuel (Page 17)

17
Altering an option or a running programme
It is possible to change any option before the
programme carries it out.
Before you make any change, you must pause
the washing machine by pressing button 8 .
Changing a running programme is possible
only by resetting it. Turn the programme
selector dial to «O» and then to the new
programme position. Start the new programme
by depressing button 8 again.
The washing water in the tub will not empty
out.
Interrupting a programme
Depress tbutton
8 to interrupt a programme
which is running, the corresponding light starts
to flash. Depress the button again to restart the
programme.
Cancelling a programme
Turn the selector dial to «O» to cancel a
programme which is running. Now you can
select a new programme.
Opening the door after the programme has
started
First set the machine to pause by pressing the
button 8 .
If the light DOOR goes off, after some minutes,
the door can be opened. If it does not switch
off, this means that the machine is already
heating, that the water level is above the
bottom edge of the door. In this cases the door
cannot be opened.
If you cannot open the door but you need to
open it you have to switch the machine off by
turning the selector dial to «O». After few
minutes the door can be opened
(Pay attention to the water level and
temperature!).
After this procedure, it will be necessary to set
the programme and the options again and then
to depress button 8 .
At the end of the programme
The machine stops automatically. Some
acustic signals sound and on the display will
appear a flashing « 0 ». The button 8 light and
the light DOOR go off. The door can be
opened.
If at the end of a programme there is water in
the tub, to empty out the water follow the
following instructions:
1. turn the programme selector dial to «O»
2. select the DRAIN or SPIN programme
3. reduce the spin speed, if needed, by means
of the button 2
4. depress button 8
5. at the end of programme, the display shows
a flashing zero « 0 », the light DOOR goes off
and it will be possible to open the door.
At the end of the cycle, turn the programme
selector dial to «O» to switch the machine off.
Remove the laundry from the drum and
carefully check that the drum is empty.
If you do not intend to carry out another wash,
close the water tap.
Leave the door open to prevent the formation
of mildew and unpleasant smells.
192997920_GB.qxd 14/12/2007 17.09 Pagina 17