Whirlpool 925 - Manuel (Page 16)

SANI RINSE TM option
(on some models)
Selecting the SANI RINSE option raises the
water temperature in the final
rinse to 150°F (65°C). SANI
RINSE is an option with the
Pots-N-Pans, Heavy, Normal,
Low Energy and China cycles. Depending
on the incoming temperature of your water,
cycle times might be longer when you select
SANI RINSE.
NOTE: SANI RINSE raises the temperature
of the final rinse to 150°F (65°C), and main-
tains that temperature 9 minutes. This high
temperature rinse sanitizes your dishes and
glassware.
Air Dry
When Air Dry is selected, the air in the
dishwasher is not heated during
the “dry” portion of a cycle. Using
Air Dry helps save energy, but
dishes take longer to dry and
some spotting can occur. Some items (such
as plastics) may need towel drying. For best
drying, use a liquid rinse agent.
NOTE: The dishwasher automatically heats
the air in the dishwasher during the “dry”
portion of the cycle unless you select Air Dry.
16
SETTING THE CONTROLS
Using Cancel/Drain
Press Cancel/Drain to cancel a cycle or
clear option selections.
To cancel a cycle:
• Press Cancel/Drain while the dishwasher
is running to start a 2-minute drain. It will
take a few seconds for the drain to start. If
desired, select a new cycle. (See the
“Changing a cycle or an option setting”
section.)
CANCEL
DRAIN
SANI
RINSE
AIR DRY
Selecting cycle options
You can press an Option pad after the
dishwasher starts as long as the cycle is
not past the point that the option is used.
For example, you can press Air Dry any
time before the Drying indicator glows.
After a wash cycle, the dishwasher remem-
bers the options used and uses the same
options in the next wash cycle unless new
options are selected or the Cancel/Drain
pad is pressed.
POWER SCOUR TM feature
(on some models)
When POWER SCOUR is selected the dish-
washer heats the water during
several portions of the Normal,
Heavy, and Pots-N-Pans cycles.
Heating the water helps improve
washing results. The Pots-N-
Pans cycle, with POWER SCOUR is
recommended for baked-on soil.
High Temp Wash
(on some models)
When High Temp Wash is selected, the
dishwasher heats the water to
140°F (60°C) during the main
wash of the Low Energy,
China, Normal and Heavy
cycles. Heating the water helps improve
washing results. The Pots-N-Pans cycle
automatically uses High Temp washes.
POWER
SCOUR
HIGH
TEMP
WASH
• You can press Cancel/Drain again to stop
the drain immediately. Remember to drain
the dishwasher again before starting a
new cycle.
NOTE: A small amount of water remaining
in the dishwasher is normal.
To clear the cycle indicators:
Press Cancel/Drain before starting the
dishwasher.
8051225 v06 EN (c28) 10/6/98 9:47 AM Page 16