Whirlpool YKHMS1850S - Manuel (Page 6)

6
MICROWAVE OVEN CONTROL
Display
When power is first supplied to the microwave oven, a “:” will
blink in the display. Touch OFF (CANCEL OFF) to stop the
blinking. If the “:” blinks in the display at any other time, a power
failure has occurred. Touch OFF and reset the clock if needed.
If “RETRY” blinks in the display for 1 second, an invalid value has
been entered. Retry your entry.
When the microwave oven is in use, the display shows cooking
power, quantities, weights and/or prompts. When the microwave
oven is not in use, the display shows the time of day or Timer
countdown.
Start
The START control starts any function. If non-sensor cooking is
interrupted, touching START will resume the preset cycle.
If the microwave oven has not been in use and the door has not
been opened in the past 5 minutes, the cooking function will not
start. Open and close the door, then touch START to start or
resume the cooking cycle.
Add a Minute
The ADD A MINUTE control automatically starts the microwave
oven at 100% power for 1 minute, and adds 1 minute of cook
time, up to 10 minutes, with each additional touch of the control.
Touching ADD A MINUTE during a cook cycle will add 1 minute
of cook time at the current cook power.
If the microwave oven has not been in use and the door has not
been opened in the past 5 minutes, the ADD A MINUTE control
will not start the cooking cycle. Open and close the door, then
touch ADD A MINUTE to start the cooking cycle.
Off
The OFF control (CANCEL OFF) clears any incorrect command
and cancels all functions except for the Demo Mode. It will not
erase the time of day. The control panel can be locked and
unlocked using the OFF control (see “Control Lock” section).
The microwave oven will also turn off when the door is opened.
Close the door and touch START to resume the cycle. A sensor
cooking cycle may not be resumed if interrupted by opening the
door.
Clock
This is a standard 12-hour clock (12:00-11:59) and does not
show a.m. or p.m.
To Set:
The microwave oven and timer must be off.
1. Touch CLOCK.
2. Touch the number pads to set the time of day.
3. Touch CLOCK or START.
To Remove:
1. Touch CLOCK.
2. Touch 0.
3. Touch CLOCK.
The time will disappear, and “:” will appear on the display.
1 2 3
SENSOR
ENTER
AUTO
COOK
REHEAT
TIMER
DEFROST
WARM
QTY TURN TABLE OFF LBS OZ
POWER
START?