Wayne 351002-001 - Manuel (Page 3)

3
Operating Instructions And Parts Manual
1. Tether Float Switch Kit 60022-001 60022-001
2. Top Cover Kit 60030-001 60030-001
3. Impeller Plate 15958 15958
4. Impeller 60000-001 60000-001
5. Volute 60016-001 60007-001
Part Numbers for Models
Ref. CDT33 SPT33, SPT50
No. Description CDT50 SSPT33, SSPT50
For Replacement Parts, call 1-800-237-0987
Please provide following information:
-Model number
-Serial number (if any)
-Part description and number as shown in parts list Address parts correspondence to:
Wayne Water Systems
101 Production Drive
Harrison, OH 45030
Specifications
Power supply requirements......120V, 60 hz
Motor .........................................Single phase, oil filled
Horsepower................................1/3 HP (CDT33, SPT33, SSPT33)
....................................................1/2 HP (CDT50, SPT50, SSPT50)
Liquid temperature range ........40°F to 120°F
Circuit requirements..................15 amps (min)
Dimensions.................................11 1 /
2
” high x 9 3 /
4
” base
Cut-in level (factory set)............13”
Cut-out level (factory set) .........7”
Construction
Motor housing .................Cold rolled steel
Volute ...............................Cast iron (CDT33, CDT50)
..........................................Glass Reinforced Thermoplastic
(SPT33, SPT50, SSPT33, SSPT50)
Impeller ............................Glass reinforced thermoplastic
Shaft .................................Low carbon steel
Seals ..................................Buna N
Discharge..........................1 1 /
2
” NPT
Motor Cover .....................Glass reinforced thermoplastic
Replacement Parts List
• Only use factory parts to repair
this pump.
www.waynewatersystems.com