Whirlpool 2199011 - Manuel (Page 18)

18
Moving
When you are moving your refrigerator to a new home,
follow these steps to prepare it for the move.
1. If your refrigerator has an automatic ice maker:
■ Turn off the water supply to the ice maker at least
one day ahead of time.
■ Disconnect the water line from the back of the
refrigerator.
■ When the last load of ice drops, raise the ice maker
arm to the OFF (up) position.
2. Remove all food from the refrigerator and pack all
frozen food in dry ice.
3. Depending on your model, turn the Thermostat Control
(or Refrigerator Control, depending on the model) to
OFF. See the “Setting the Controls” section.
4. Unplug the refrigerator.
5. Empty water from the defrost pan.
6. Clean, wipe, and dry thoroughly.
7. Take out all removable parts, wrap them well, and tape
them together so they don’t shift and rattle during the
move.
8. Depending on the model, raise the front of the
refrigerator so it rolls easier OR screw in the leveling
legs so they don't scrape the floor. See the "Door
Closing and Alignment" section.
9. Tape the doors shut and the power cord to the
refrigerator cabinet.
When you get to your new home, put everything back
and refer to the “Installing Your Refrigerator” section for
preparation instructions. Also, if your refrigerator has an
automatic ice maker, remember to reconnect the water
supply to the refrigerator.
TROUBLESHOOTING
Try the solutions suggested here first in order to
avoid the cost of an unnecessary service call.
Your refrigerator will not operate
■ ■ ■ ■ Is the power supply cord unplugged?
Firmly plug the cord into a live outlet with proper voltage.
■ ■ ■ ■ Has a household fuse or circuit breaker tripped?
Replace the fuse or reset the circuit.
■ ■ ■ ■ Is the refrigerator control turned to the “OFF”
position?
Refer to the “Setting the Control” section.
■ ■ ■ ■ Is the refrigerator defrosting?
Recheck to see if the refrigerator is operating in 30
minutes. Your refrigerator will regularly run an automatic
defrost cycle.
The lights do not work
■ ■ ■ ■ Is the power supply cord unplugged?
Firmly plug the cord into a live outlet with proper voltage.
■ ■ ■ ■ Is a light bulb loose in the socket?
Turn the Temperature Control to OFF. Disconnect the
refrigerator from the electrical supply. Gently remove the
bulb and reinsert. Then reconnect the refrigerator to the
electrical supply and reset the refrigerator control.
■ ■ ■ ■ Has a light bulb burned out?
Replace with an appliance bulb of the same wattage,
size, and shape. See the “Changing the Light Bulbs”
section.
There is water in the defrost drain pan
■ ■ ■ ■ Is the refrigerator defrosting?
The water will evaporate. It is normal for water to drip
into the defrost pan.
■ ■ ■ ■ Is it more humid than normal?
Expect that the water in the defrost pan will take longer
to evaporate. This is normal when it is hot or humid.