Complete installation – Whirlpool Cabrio W10151493A Manuel d'utilisation

Page 16

Advertising
background image

16

4. Install the 2 hinges to the front panel of the dryer using

4 screws. Use the non-slotted side to attach the hinge to the
front panel.

5. Install screws in the top hinge holes in the door. Do not

tighten screws. Leave approximately ¼" (5 mm) of screw
exposed.

6. Hang door by placing screw heads into top slotted holes of

hinges and slide door down. Align bottom screw holes in
hinge and door. Install two bottom screws. Tighten all hinge
screws.

7. Close door to engage door strike.

Complete Installation

1. Check that all parts are now installed. If there is an extra part,

go back through the steps to see which step was skipped.

2. Check that you have all of your tools.

3. Dispose of/recycle all packaging materials.

4. Check the dryer’s final location. Be sure the vent is not

crushed or kinked.

5. Check that the dryer is level. See “Level Dryer.”

6. In the U.S.A.

For power supply cord installation, plug into a grounded
outlet. For direct wire installation, turn on power.

In Canada

Plug into a grounded 4 prong outlet. Turn on power.

7. Remove any protective film or tape remaining on the dryer.

NOTE: Glass door models have a protective film on the
window that should be removed.

8. Read “Dryer Use.”

9. Wipe the dryer drum interior thoroughly with a damp cloth to

remove any dust.

10. Test dryer operation by selecting a Timed Dry heated cycle

and starting the dryer. For this test, do not select the Air Only
modifier.

If the dryer will not start, check the following:

Controls are set in a running or “On” position.

Start button has been pushed firmly.

Dryer is plugged into an outlet and/or electrical supply
is on.

Household fuse is intact and tight, or circuit breaker has
not tripped.

Dryer door is closed.

This dryer automatically runs an installation diagnostic routine at
the start of its first cycle.

If you receive an “L2” code, there may be a problem with your
home power supply keeping the dryer’s heater from turning
on.
See “Troubleshooting.”

If you receive an “AF” code, your dryer vent may be crushed
or blocked.
See “Troubleshooting.”

NOTE: You may notice a burning odor when the dryer is first
heated. This odor is common when the heating element is first
used. The odor will go away.

A. Install these screws first.

A

A

Advertising
Ce manuel est liée aux produits suivants: