Viking VEV900 - Manuel (Page 4)

4
99043131E
USE AND CARE
Disconnect electrical power supply and lock out
service panel before cleaning or servicing this unit.
CLEANING
Remove cover and carefully vacuum blower and
inside of housing. Be careful not to bend or otherwise
damage blower wheel.
MOTOR LUBRICATION
The motor is permanently lubricated. Do not oil or
disassemble motor.
INSTALL THE ROUGH-IN PLATE
1. Run 10" round steel ductwork, from exterior blower
to the installation location. For best performance,
use the straightest possible duct run and the few-
est number of elbows. Tape all joints.
2. Run 120 VAC electrical power cable from service
panel and from remote blower to installation loca-
tion.
3. Remove wiring box cover. Remove knockouts
from the wiring box. Feed 6" of power cable through
openings and attach cables to wiring box with
appropriate connectors.
4. Wire black to black, white to white, and green or
bare wire beneath green ground screw. Replace
wiring box cover.
5. Attach rough-in plate to the studs at the inside top
of hood with (4) #10-24 nuts provided.
6. Connect ductwork to rough-in plate and tape joint.
GREEN
WHITE
BLACK
GREEN
WHITE
BLACK
BLACK
WHITE
GREEN
BLACK
WHITE
GREEN
ROUGH-IN PLATE LEAD ROUGH-IN PLATE LEAD
WIRING BOX
LINE IN
120 VAC
60 HZ
10 A MAX.
EXTERIOR
BLOWER
VIKING RANGE CORPORATION
GREENWOOD, MISSISSIPPI 38930 USA
10" ROUND
DUCT
POWER
CABLE
WIRE
BOX
COVER
HOUSE
WIRING
7. Turn on power and check blower operation.
10" DAMPER
MOUNTS INSIDE
DUCTWORK AT
LEAST 3" ABOVE
CANOPY OUTLET