Viking DEV900 - Manuel (Page 2)

2
11" dia.
hole
29½"
11" dia.
hole
1¼"
dia. hole
12 7 /
8
"
10¾"
25"
7¼" 7¼"
1¼"
dia. hole
9 1 /
8
" 9 1 /
8
"
W
a
ll
S
tu
d
10¾"
24¾"
28¼"
W
a
ll Stud
12 7 /
8
"
W
a
ll
S
tu
d
W
a
ll Stud
REMOVE
SIDING
REMOVE
SIDING
8½" 8½"
Pilot Pilot
Hole Hole
Pilot
Hole
OUTSIDE - WALL VIEW OUTSIDE - WALL VIEW
1. Locate the ventilator on the rear slope of the roof.
Place it in a location to minimize duct run. The
location should be free of obstacles (T.V. leads,
electrical lines, etc.). Bear in mind, if the ventilator
top is level with the roof peak, it will not be seen
from the street. Keep this approximate location in
mind as you work from within the attic.
1. Choose a position on the outside wall. Make sure
that no wall studs, pipes or wires run through the
opening area.
PREPARE THE INSTALLATION
LOCATION
ROOF INSTALLATIONS
PREPARE THE INSTALLATION
LOCATION
WALL INSTALLATIONS
ALL INSTALLATIONS
5. For flat roof installations, build a curb that will
mount the ventilator at a minimum pitch of 2/12.
See Figure 2. Discharge end of the ventilator
should be pointed away from prevailing winds.
20½"
11"
dia.
hole
20½"
10 3 /
8
"
1¼"
dia. hole
10 3 /
8
"
8½" 8½"
20¾" 20¾"
7¼" 7¼"
1¼"
dia. hole
9 1 /
8
" 9 1 /
8
"
REMOVE
SHINGLES
Roof Rafter
REMOVE
SHINGLES
11"
dia.
hole
Roof Rafter
Pilot Pilot
Hole
Hole
Pilot
Hole
OUTSIDE - ROOF VIEW OUTSIDE - ROOF VIEW
From inside the attic space:
2.
Drill a PILOT HOLE up through the roof, 8½"
from the
inside edge of a ROOF RAFTER.
From outside - on the roof:
3.
Measure and mark the 20¾" x 20½" rectangle.
Cut and remove only the shingles inside this
rectangle.
4. Measure and mark the 11" DIAMETER HOLE
and the 1¼" DIAMETER HOLE. Cut these holes
all the way through the roof.
Figure 1
PREPARE THE VENTILATOR
1. Unpack the ventilator assembly.
2. Remove the cover and screws.
3. Remove and discard cardboard from ventilator
wheel.
4. Remove the wiring box cover and screws.
5. Attach an appropriate U.L. approved cable con-
nector in the hole at the rear of the wiring box.
From inside the wall:
2.
Drill a PILOT HOLE through the wall, 8½" from
the
inside edge of a WALL STUD.
From outside - on the wall:
3.
Measure and mark the 25" x 29½" rectangle. Cut
and remove only the siding inside this rectangle.
4. Measure and mark the 11" DIAMETER HOLE
and the 1¼" DIAMETER HOLE. Cut these holes
all the way through the wall.
Figure 3
6¾"
2"
28¼"
24¾"
2"
Figure 2