Valor Auto Companion Inc. MILES INDUSTRIES 1210DKA - Manuel

4001303-01
31-3/4”
35-3/4”
Overview
1200 Heater
Backing Plate
Wall Finish
Alhambra Doors
1210DKA Alhambra
Door Kit
(incl. magnet bracket)
Magnet
Bracket
© Copyright Miles Industries Ltd., 2007.
1210DKA Alhambra Door Kit
The 1210DKA Alhambra Door Kit may be fitted to the Valor model 1200 heater, either at the time the heater is installed
or retrofitted afterwards (provided existing wall and hearth finish allow—see Note above). Installation of the Alhambra
doors affect mantle clearances, framing dimensions, or other specifications listed in the heater installation manual—see
installation manual packed with the heater. The 1210DKA Alhambra Doors may also be installed with optional
614CVI, 615CVI Cast Surrounds, 616STK, 617STK Stone Trim Kits (see installation instructions with each kit).
NOTE: The bottom of the plate is flush
with the bottom of the heater. Bottom
of the heater MUST be flush with or
higher than the finished hearth.
NOTE: To install the kit’s backing plate, the surface of the finished hearth or floor must be at
the same level as the bottom of the heater. Please be aware that the backing plate mounting
can ONLY accommodate 1/2” wall thickness.
Note: This kit must be installed or serviced by a qualified installer, service agency or gas supplier.
These instructions are to be used in conjunction with the main installation instructions for the 1200.
CSA approved for use with Valor Model 1200 Heater ONLY
INSTALLATION INSTRUCTIONS
Mantel or Shelf Clearances
For Mantel of Shelf Clearances, see the Installation manual provided with the 1200DV Ventana engine.