Remington EL-7 16-inch - Manuel (Page 14)

14 105020
ELECTRIC CHAIN SAW
®
For more information, visit www.desatech.com
Flat File
Depth Gauge
Tool
Depth Gauge
Depth
Gauge
Slot
Front Corner
Filing Cutter Depth Gauges
The cutter depth gauge clearance is reduced
as cutters are sharpened. After every second
or third sharpening, reset cutter depth gauges.
1. Place depth gauge tool firmly across top
of two cutters. Make sure depth gauge
enters slot in depth gauge tool (see Fig-
ure 21).
2. Use medium flat file. File depth gauge
level with depth gauge tool.
3. Remove depth gauge tool. With flat file,
round off front corner of cutter depth
gauge (see Figure 22).
Figure 21 - Depth Gauge Tool On Chain
Figure 22 - Round Off Front Corner Of
Depth Gauge
REPLACEMENT
PARTS
STORAGE
If storing saw for more than 30 days, fol-
low steps below.
1. Drain oil tank.
2. Remove and clean guide bar and chain.
Clean guide bar and chain by soaking
in petroleum based solvent or mild soap
and water mixture.
3. Dry guide bar and chain.
4. Place chain in container filled with oil.
This will prevent rust.
5. Wipe a thin coating of oil over surface
of guide bar.
6. Wipe off outside of saw body. Do this
with soft cloth dampened with a mild
soap and water mixture.
7. Store chain saw
• in a high or locked place, out of
children’s reach
• in a dry place
• in a carrying case or with scabbard
over guide bar
• with oil cap tight and saw upside
down to prevent excess oil seepage
After several hand filings, have authorized
service center or sharpening service machine
sharpen chain. This will insure even filing.
Replacing Saw Chain
Replace chain when cutters are too worn to
sharpen or when chain breaks. Only use re-
placement chain noted in this manual. Al-
ways include new drive sprocket when re-
placing chain. This will maintain proper
driving of chain.
Note: For proper chain and
drive sprocket, see Replacement Parts.
Purchase these parts from your local dealer.
Part
Number
Description
EL-7
097572-03S Guide bar, 40,6 cm (16")
091375-02S Chain, 40,6 cm (16")
EL-7
097570-01S Guide bar, 35,5 cm (14")
091374-02S Chain, 35,5 cm (14")
LNT-3
097568-02S Guide bar, 30,5 cm (12")
091373S Chain, 30,5 cm (12")
LNT-3
097567-01S Guide bar, 25,4 cm (10")
091371S Chain, 25,4 cm (10")
LNT-2
097567-01S Guide bar, 25,4 cm (10")
091371-02S Chain, 25,4 cm (10")
104302-01S* Guide bar, 20,3 cm (8")
104301S Chain, 20,3 cm (8")
*When ordering replacement Guide Bar
104302-01S you must also order replace-
ment Chain 104301S.
PoleSaw
104302-01S Guide bar, 20,3 cm (8")
104301S Chain, 20,3 cm (8")
General
075752 Drive sprocket
079417-03 Wrench/Screwdriver
WARNING: Use only replace-
ment parts described in this
manual. Use of other parts could
damage saw or injure operator.
CLEANING AND
MAINTENANCE
Continued