Razor RipRider 360 - Manuel (Page 5)

4
4
Locate the threaded hole
on the rear underside of frame.
Screw caster wheel into hole.
5
Tighten with 5mm hexagonal
wrench.
❑ Attaching the Rear Caster Wheels
1
Remove the four Allen socket
screws and Allen long screws
from the frame with two 5mm
hexagonal wrenches. One on top
and one on bottom.
2
Align four holes in seat with
four holes in frame. Insert Allen
long screws through the bottom of
the frame.
❑ Attaching the Seat
ASSEMBLY AND SET-UP
3
Secure with Allen socket
screws. Tighten screws with two
5mm hexagonal wrenches. One on
top and one on bottom.
2
Insert one small spacer between
wheel and caster and align holes.
Insert axle bolt through caster, small
spacer, wheel and into small spacer
on other side of wheel.
Need Help? Visit our web site for replacement parts, product support, live chat and a list of
authorized service centers at
www.razor.com or call toll-free at 866-467-2967 Monday - Friday
8:00 AM - 5:00 PM Pacific Time.
3
Insert Allen socket screw
through caster, small spacer and
into axle bolt. Tighten with 5mm
hexagonal wrench on both sides.
1
Insert large spacer into wheel
and insert bearings into each side
of wheel. Make sure all holes are
aligned. Insert wheel into caster.