Roberts Gorden 60007 Manuel d'utilisation

Page 7

Advertising
background image

- 7 -

SAW OPERATION

1. Make sure you have read this manual completely before operating your saw.

2. NOTE: The saw motor has two ON/OFF switches. Both switches must be “ON” for your saw to operate.

• One switch is located on the motor housing. Push this switch to the “DOWN” and “LOCKED” position.

• The second switch is located on the motor mounting block, enclosed in a protective housing. This rocker switch has
“I” and “O” markings. Press the “I” to turn the switch “ON”. This switch should be used as the primary ON/OFF switch
for saw operation.

3. Make sure that there is sufficient water in the water pan to cover the inlet on the water pump, and that water is being

supplied to the saw blade before attempting to cut any material.

4. Make sure your material is positioned properly on the saw table before beginning your cut. Feed your material slowly

into the blade. DO NOT force material. The blade will cut smoother and faster if these steps are followed.

5. ALWAYS practice “SAFETY FIRST”. Wear eye safety goggles, a dust mask and gloves when operating this saw. Discard

cracked, bent, chipped, or damaged blades.

ENGLISH

SAW MAINTENANCE

WARNING: DO NOT SERVICE, CLEAN OR MAINTAIN THE SAW WITHOUT FIRST TURNING OFF THE MOTOR AND
UNPLUGGING THE SAW FROM ITS POWER SOURCE. FAILURE TO DO SO MAY RESULT IN SERIOUS INJURY TO THE
OPERATOR.

1. For longest life and best performance, clean the saw after every use.

2. Wipe off all exterior surfaces and keep the cutting table clean and free to tile chips and debris.

3. Wipe off both the guide bars and the rollers on the cutting table.

4. Place light machine oil on the guide bar to facilitate smooth travel of the linear guide assembly.

5. The guide bars are specially treated to give you years of operation.

6. Always check the blade for cracks or signs of fatigue.

DOs & DON’Ts FOR DIAMOND BLADES

DOs

1. Inspect blades daily for cracks or uneven wear. Discard cracked. chipped or bent blades!

2. Always use manufacturer’s recommendation for matching the right blade with the right material being cut.

3. Inspect the arbor shaft for uneven wear before mounting the blade.

4. Always use blades with the correct arbor size on a compatible arbor shaft.

5. Ensure the blade is mounted with the rotation arrow in the proper direction and is securely tightened with the wrench.

6. Always wear the proper safety equipment at all times when operating the saw. Wear goggles and dust mask at all times

when operating saw.

7. Periodically check the blade for cracks or bond fatigue.

8. Always have a continuous flow of water on both sides of the blade before cutting any material.

DON’Ts

1. Do not operate the saw without all safety guards in position.

2. Do not operate the saw with blades larger or smaller than 7".

3. Do not cut dry with blades marked “Use Wet”.

4. Do not exceed maximum RPMs recommended by the blade manufacturer.

5. Do not force the material into the blade. Let the blade cut at its own speed.

6. Do not cut material not recommended by the blade manufacturer.

Advertising