Petsafe In-Ground Fence Kit - Manuel (Page 3)

www.petsafe.net 3
This Receiver Collar uses a replaceable PetSafe ®
battery (RFA-67). This unique battery is designed to
make battery replacement easier and increase water
protection.
To insert the battery, align the symbols on the battery
(arrow) and Receiver Collar (triangle). Using the
edge of the Test Light Tool as shown, turn the battery
clockwise until the arrow lines up with the lock symbol
on the housing (1A, 1B).
To remove the battery, turn the battery counter
clockwise using the edge of the Test Light Tool as shown,
(1C, 1D). DO NOT attempt to cut into or pry open the
battery. Be sure to discard the used battery properly.
A replacement PetSafe ® battery (RFA-67) can be
found at many retailers. Contact the Customer Care
Centre or visit our website at www.petsafe.net for a
list of common retailers.
1A 1B
1D 1C
To Change the Mode
Read all the steps before attempting to change the mode.
1. With the battery installed, press the Mode Button and release
it when the Receiver Indicator Light lights up (1E).
2. The Receiver Indicator Light will emit a number of fl ashes representing
the mode setting (1F).
3. Change the mode by pressing and releasing the Mode Button within 5
seconds of the previous fl ashes.
The modes cycle from 1 to 4. Pushing the Mode Button while the
Receiver Collar is on Mode 4 will cause the Receiver Collar to revert to
Mode 1. Refer to the Function and Response Table to choose the Mode
that best fi ts your pet.
1E
1F
The Receiver Collar is equipped to automatically increase the level of Static Correction
the longer your pet remains in the Static Correction Zone if the collar is set at mode 1-3.
Prepare the Receiver Collar
To Insert and Remove the Battery
Note: Do not install the battery while the Receiver Collar is on your pet.