Pioneer DEH-P3000IB - Manuel (Page 26)

Setting the rear output and
subwoofer controller
This unit
’s rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (
REAR SP:FULL/PREOUT:REAR)
or subwoofer ( REAR SP:SUB W/
PREOUT:SUB W) connection. If you switch the
rear output setting to
REAR SP:SUB W, you
can connect a rear speaker lead directly to a
subwoofer without using an auxiliary amp.
Initially, the unit is set for rear full-range speak-
er connection (
REAR SP:FULL). When rear out-
put is connected to full range speakers (when
REAR SP:FULL is selected), you can connect
the RCA subwoofer output to a subwoofer. In
this case, you can select whether to use the
subwoofer controller
’s (low pass filter, phase)
built-in PREOUT:SUB W or the auxiliary
PREOUT:REAR.
1 Use MULTI-CONTROL to select
SW CONTROL.
2 Press MULTI-CONTROL to display the
setting mode.
# Press BACK to return to the previous display.
3 Press MULTI-CONTROL to select the seg-
ment you wish to set.
Press
MULTI-CONTROL repeatedly to switch
the segment in the following order:
REAR SP (rear speaker setting)
—PREOUT
(RCA output setting)
4 Use MULTI-CONTROL to select the de-
sired setting.
Turn to change the setting.
When
REAR SP (rear speaker setting) is se-
lected.
REAR SP:SUB W (subwoofer)
—REAR SP:FULL
(full-range speaker)
When
PREOUT (RCA output setting) is se-
lected.
PREOUT:SUB W (subwoofer)
—PREOUT:REAR
(full-range speaker)
# When no subwoofer is connected to the rear
output, select
REAR SP:FULL.
# When a subwoofer is connected to the rear
output, set for subwoofer
REAR SP:SUB W.
Notes
! Even if you change this setting, there is no
output unless you turn the subwoofer output
on (refer to Using subwoofer output on page
23).
! If you change this setting, subwoofer output
in the audio menu return to the factory set-
tings.
! Both rear speaker lead outputs and RCA rear
output are switched simultaneously in this
setting.
Switching the Ever Scroll
When Ever Scroll is set to ON, recorded text in-
formation scrolls continuously in the display.
Set to OFF if you prefer the information to
scroll just once.
1 Use MULTI-CONTROL to select
EVER SCROLL.
2 Press MULTI-CONTROL to turn the Ever
Scroll on.
# To turn the Ever Scroll off, press
MULTI-CONTROL again.
Activating the BT AUDIO source
You need to activate the BT AUDIO source in
order to use a Bluetooth audio player.
! You can only operate this function when
Bluetooth adapter (e.g. CD-BTB200) is con-
nected to this unit.
1 Use MULTI-CONTROL to select
BT AUDIO.
2 Press MULTI-CONTROL to turn the
BT AUDIO source on.
# To turn the BT AUDIO source off, press
MULTI-CONTROL again.
Initial Settings
En
26
Section
04