Pioneer IDK-01 - Manuel (Page 5)

Before you start 01
5
En
English
Français
Deutsch
Nederlands
Italiano
Español
Chapter 1
Before you start
Checking what’s in the box
Please check that you've received the following
supplied accessories:
• Remote control
•
Lithium battery (CR2025)
• iPod type adapter x6
• AC adapter
• Audio cable (2 m / 6.6 ft.) red/white
• Video cable (2 m / 6.6 ft.) yellow
• SR cable (2 m / 6.6 ft.)
• These operating instructions
• Warranty card (Japan / North America)
Inserting the battery
Reseat the lithium battery (CR2025) in the
remote control as shown right. When you
notice a decrease in the operating range,
replace the battery in the same manner.
1 Push the release tab to the right to
open the battery casing.
2
Pull out the battery casing.
3 Remove the battery from the casing.
If you're doing this for the first time, remove the
protective seal from the battery supplied with
the system before re-inserting it.
4 Place a new battery in the casing.
Make sure the  side of the battery is facing up
when you place it in the space provided.
Caution
When using lithium batteries, please observe
the following:
• Dispose of used battery cells immediately
after replacement. Keep away from
children.
• If swallowed, please contact a doctor
immediately.
• Lithium batteries may present a fire or
chemical burn hazard if misused. Do not
disassemble, heat above 100°C (212°F), or
incinerate.
• Remove the battery if the unit isn’t going to
be used for a month or more.
• When disposing of used batteries, please
comply with governmental regulations or
environmental public instruction’s rules
that apply in your country or area.
• There is danger of explosion if the battery is
incorrectly replaced. Make sure to replace
only with the same type recommended by
the manufacturer.
• Do not use or store batteries in direct
sunlight or other excessively hot place,
such as inside a car or near a heater. This
can cause batteries to leak, overheat,
explode or catch fire. It can also reduce the
life or performance of batteries.
Cleaning the unit
• Use a polishing cloth or dry cloth to wipe
off dust and dirt.
• When the surface is dirty, wipe with a soft
cloth dipped in some neutral cleanser diluted
five or six times with water, and wrung out
well, and then wipe again with a dry cloth. Do
not use furniture wax or cleansers.
• Never use thinners, benzine, insecticide
sprays or other chemicals on or near this
unit, since these will corrode the surface.
1
2
4
3
IDK-01.book Page 5 Friday, August 4, 2006 9:54 AM