Philips HTB7150 - Manuel (Page 22)

22 EN
3
Select a picture, and then press (Play) to
start the slideshow.
4
Press to stop slideshow.
5
Press again to stop music.
Note
• Make sure that the picture and audio formats are
supported by your home theater (see 'File formats' on
page 39).
Radio
Listen to FM radio on your home theater, and
store up to 40 radio stations.
Note
•
AM and digital radio are not supported.
•
If no stereo signal is detected, or if fewer than five
stations are found, you are prompted to install the
radio stations again.
1
Connect the FM antenna to the
ANTENNA FM 75 on your home
theater.
• For the best reception, place the
antenna away from your TV or other
sources of radiation.
2
Press Source buttons repeatedly until
RADIO appears on the display panel.
» If you have already installed the radio
stations, the last channel that you
listened to is played.
» If you have not installed any radio
stations, the message AUTO
INSTALL...PRESS PLAY appears on
the display panel. Press (Play).
3
Use the remote control to listen or to
change radio stations.
Play buttons
Button Action
/
or
Alphanumeric
buttons
Select a preset radio station.
Navigation
buttons
Left/Right: Search for a radio
station.
Up/Down: Fine tune a radio
frequency.
Press to stop the installation of
radio stations.
BACK Press and hold to erase the
preset radio station.
OPTIONS Manual:
1) Press OPTIONS. 2)
Press / to select your
preset. 3) Press OPTIONS
again to store the radio
station.
Automatic: Press and hold for
three seconds to reinstall the
radio stations.
SUBTITLE Toggle between the stereo
and mono sounds.
Tuning grid
In some countries, you can toggle the FM tuning
grid between 50 kHz and 100 kHz. When you
switch the tuning grid, all preset radio stations
are erased.
1
Press Source buttons repeatedly until
RADIO appears on the display panel.
2
Press .
3
Press and hold (Play) to toggle between
50 kHz or 100 kHz.
MP3 player
Connect a MP3 player to play audio files.
What you need