Panasonic CF-VDL02BM - Manuel (Page 16)

E
16
Auto Config
Auto Configuration automatically adjusts image posi-
tion, clock, and phase.
A confirmation box is displayed. The default selection
is [Yes]. Press to execute the menu. If you want to
cancel, select [No] and press .
To save the adjusted value, select [Brightness], then press .
(Auto Configuration)
Yes No
Miscellaneous
Init NVRam
OSD Timeout
OSD Position
Select the item by pressing or , then press .
Init NVRam
All values of the OSD menu are set to default.
A confirmation box is displayed. The default selection
is [Yes]. Press to execute the menu. (If you want to
cancel, select [No] and press .) This setting is acti-
vated by turning off the power to the LCD Monitor and
then turning the power back on again.
OSD Timeout
OSD Timeout is used to set the OSD idle time-out. If
no active action, key press or automatic configuration
occurs for the defined period, the OSD menu is closed.
There are four OSD time-out values available.
Select the item by pressing or , then press .
OSD Position
The sub-menu is displayed.
Select the item by pressing or , then press .
The sub-menu is displayed.
Adjust the OSD Position by pressing or , then press
. (To cancel, press and then turn off the power to
the LCD Monitor. When the power is turned on again,
the operation will be canceled.)
(Miscellaneous)
This menu is used to display information about the sys-
tem. The OSD window is displayed. If
is pressed,
the information window is closed and the main menu is
displayed.
(Information)
Information
Version:
V-Freq-:
H-Freq-:
PixelCLk:
Width:
Height:
3 Press
The OSD main menu disappears.
Adjusting the LCD Monitor
Auto Phase
A confirmation box is displayed. The default selection
is [Yes]. Press to adjust the phase automatically. If
you want to cancel, select [No] and press .
To save the adjusted value, select [Phase] or [Clock],
then press .