Preparing the remote control – Panasonic SC-SP100 Manuel d'utilisation
Page 6
6
RQTX1012
ENGLISH
ESP
AÑOL
ENGLISH
Preparing the remote control
Before using the remote control for the fi rst time, remove the insulation
sheet.
Replace the remote control battery when it stops operating, or when
the range seems reduced.
Rear view
Pull
CR2025
Lithium
Button-Type
battery
(CR2025)
1
Insert an object and push down
to unlock the catch.
Aim at the remote control signal sensor (
\
page 8), avoiding
obstacles, at a maximum range of 7 m (23 feet) directly in front of the
main unit.
• Insert with poles aligned.
• Do not touch the terminals (+ and –) with metal objects.
• Do not recharge, disassemble, remodel, heat or throw into fi re.
• Keep out of reach of children.
• Do not heat or expose to fl ame.
• Do not leave the battery(ies) in an automobile exposed to direct
sunlight for a long period of time with doors and windows closed.
• Remove the battery if the remote control is not going to be used for a
long period of time. Store in a cool, dark place.
If any electrolyte should come into contact with your hands or clothes,
wash it off thoroughly with water.
If any electrolyte should come into contact with your eyes, never rub
the eyes.
Rinse eyes thoroughly with water, and then consult a doctor.
Warning
Keep the Button-Type battery out of reach of children to prevent
swallowing.
Warning
Risk of fi re, explosion and burns. Do not disassemble, heat above
60°C (140°F) or incinerate.
CAUTION
Danger of explosion if battery is incorrectly replaced. Replace
only with the same or equivalent type recommended by the
manufacturer. Dispose of used batteries according to the
manufacturer’s instructions.
< For USA-California Only >
This product contains a CR Coin Cell Lithium Battery which
contains Perchlorate Material - special handling may apply.
See www.dtsc.ca.gov/hazardouswaste/perchlorate.
RQTX1012-3Y_us_le.indd 6
RQTX1012-3Y_us_le.indd 6
12/28/09 12:01:43 PM
12/28/09 12:01:43 PM