The other setup menu, Dynamic range control setup, Dual mono setup – Pioneer XRE3138-A Manuel d'utilisation

Page 31: Lfe attenuator setup, The system setup menu 06

Advertising
background image

The System Setup menu

06

31

En

English

Français

Deutsch

Nederlands

Italiano

Español

• If you connect any source component to

the receiver using a component video
input, you should also have your TV
connected to this receiver's

COMPONENT

VIDEO MONITOR OUT jacks.

The Other setup menu

The Other menu is where you can make
customized settings to reflect how you are
using the receiver.

1

Select OTHER from the System Setup

menu.

2

Use

/ to select the setting you want to

adjust then press ENTER.
If you are doing this for the first time, you may
want to adjust these settings in order:

DRC – Specify the amount of dynamic
range adjustment to Dolby Digital
soundtracks (see Dynamic Range Control
Setup
below).

DUALMONO – Isolate one channel when
listening to discs with dual mono encoding
(see Dual Mono Setup below).

LFE ATT – Set the attenuator level for the
LFE channel (LFE Attenuator Setup below).

3

Use

/ to make the adjustments

necessary for each setting, pressing RETURN
to confirm after each screen.

Dynamic Range Control Setup

• Default setting:

OFF

Specifies the amount of dynamic range
adjustment to Dolby Digital or DTS
soundtracks:

DRC OFF – No dynamic range adjustment
(use when listening at higher volume).

DRC MAX – Dynamic range is reduced
(loud sounds are reduced in volume while
quieter sounds are increased).

DRC MID – Mid setting.

Dual Mono Setup

Default setting:

CH1

Specifies how dual mono encoded Dolby

Digital soundtracks should be played:

1

CH1 – Only channel 1 is played

CH2 – Only channel 2 is played

CH1 CH2 – Both channels are played
through the front speakers

LFE Attenuator Setup

• Default setting:

ATT 0 dB

Set the LFE attenuator as necessary to prevent
ultra-low bass tones (included with some
Dolby Digital and DTS audio sources) from
distorting the sound from the speakers:

LFEATT 0 – No limiting (recommended
setting)

LFEATT 10 – 10dB of limiting

LFEATT ** – No sound from LFE channel

Note

1 This setting works only with dual mono encoded Dolby Digital and DTS soundtracks.

VSX_517.fm Page 31 Friday, December 1, 2006 2:41 PM

Advertising