Panasonic AJ-PCD20P - Manuel (Page 11)

E-10
EN
G
L
IS
H
Installation
(continue)
To Mount the P2 drive in a Personal Computer 5-inch Bay
1
Turn OFF the personal computer’s power.
2
Undo the six screws and remove the cover.
3
Mount the P2 drive in a 5-inch bay on the
personal computer. Use the screws supplied
with the P2 drive for mounting.
Please refer to your computer’s
instruction manual for guidance in
mounting to 5-inch bay drives.
<Notes>
z The P2 drive may not be able to be
fastened securely in some types of
personal computers.
z If all 5-inch bays are occupied, you will
need to remove one of the built-in drives to
make room for the P2 drive.
z The P2 drive should be used in a personal
computer whose design allows the front
panel of the Drive to be manipulated.
4
Plug a USB 2.0 cable B connector into the
USB connector on the P2 drive. then plug the
other end of the USB 2.0 cable into the USB
2.0 port on the personal computer.
<Note>
USB 2.0 connector pinouts vary according to
the type of motherboard type. Check your
computerís instruction manual before
purchasing a commercially available USB
2.0 cable (shielded).
5
Connect the P2 drive to the internal power
cable (4 pins) of the personal computer.
USB 2.0
DC IN 16V DC IN 12V
IEEE 1394b
Holes for securing the screws
(the other side is the same.)
USB 2.0 connector
USB 2.0
DC IN 16V
DC IN 12V
IEEE 1394b
USB 2.0
DC IN 16V
DC IN 12V
IEEE 1394b
Power cable
P_AJ-PCD20.book 10 ページ ２００６年６月２８日 水曜日 午前９時４９分