Panasonic WX-C3010 - Manuel (Page 21)

21
3. Insert the power plug into the power cord inlet.
4. Push the holder forward until the holder touches the
power plug.
5. Lock the holder.
6. Clamp the AC cable with the provided clamp, and
secure the AC cable clamper to the wall by fastening the
screws.
AUX SP + (8
Ω
)
CONNECTOR 1
ORDER INTERFACE
1
AUX SP GND
2
OUTSIDE SP + (8
Ω
)
3
OUTSIDE SP GND
4
OUTSIDE MIC +
5
OUTSIDE MIC
–
6
OUTSIDE MIC GND
7
V/DET 1 IN
8
COM
9
V/DET 2 IN
10
SPEED TEAM
CONNECTOR 3
POS INTERFACE
1
TALK LOCK RELEASE
2
MANAGER SELECT
3
PAGE SELECT
4
IN COM
5
POS AUDIO IN
6
POS AUDIO GND
7
POS AUDIO OUT
8
POS AUDIO GND
9
V/DET 1
CONNECTOR 4
POS INTERFACE
1
V/DET 2
2
TALK
3
PAGE
4
OUT COM
5
NIGHT MODE
6
OUTSIDE SP LEVEL
7
CONNECTOR 5
1 2
N.C N.C
3 4 5
COM
6
CONNECTOR 6
MAINTENANCE
DOUBLE-DRIVE-THRU Use a LAN cable with the shield type
CONNECTOR 7
DDT INTERFACE
AUX MIC +
CONNECTOR 2
ORDER INTERFACE
1
AUX MIC
–
2
AUX MIC GND
3
AUX MIC PTT
4
COM
5
DEVICE CONTROL
6
COM
7
N.C
8
●
Refer to the following lists attached on the inside of the terminal cover to make connections.
■
Clamping the Power Plug and
Power Cord
Important:
Surely clamp the power plug to this center module and
screw the AC cable to the wall using the provided AC
cable clamper.
1. Insert an AC cable holder into the hole under the AC
inlet.
2. Slide the holder to the backward by pushing down the
clamp lever.
Slide the holder
to the backward
by pushing down
the lever.
3
2
150 mm - 200 mm
{5-15/16" - 7-7/8"}
AC cable holder
AC cable clamper