Panasonic WV-NW474S - Manuel (Page 31)

-31-
TROUBLESHOOTING
Symptom
No picture is displayed.
HTML documents are not displayed.
• Is the 24 V AC cable firmly connected?
• Is the video cable or network cable connected properly?
• HTML files in the camera might be broken. Initializing is
required.
12
30
Cannot access the camera from the
browser. • Are the network cables connected properly?
• Is the status indicator lamp of the network connection termi-
nal on?
If not, a network connection has not been established or the
other devices are not in operation.
• Is a valid IP address set for the camera?
• Are you connecting to a wrong IP address?
Open the command prompt on your PC and enter:
>ping (enter here the IP address set for the camera).
If the camera replies, the connection is correct.
If not, set the correct IP address for your PC and/or to the
camera.
12, 16-19
What to do Reference page
INITIALIZING
You can reset the following data back to the factory
default settings.
Camera Setup
Setup Menu (PC oriented)
HTML files
■ Initializing the Camera Menu
• Move the cursor to CAMERA RESET.
• Hold down [Left], [Right], and [SET] buttons simulta-
neously for 2 seconds on the camera, or click the All
Reset button on your computer display.
■ Initializing the Setup Menu
• In the power-on state, press the [Up] and [Down]
buttons simultaneously while holding down the but-
ton A.
Hold down the button A for 15 seconds. It will take
about 10 seconds to complete the initializing. Be
sure to continue supplying power to the camera
while initializing.
Notes:
• Clock calibration is required even after initializing
the setup menu.
• Try again if the previous initializing failed.
■ Initializing HTML Files
• In the power-on state, press the side panel buttons,
[Up] and [Down] simultaneously while holding down
the button B.
Hold down the button B for 15 seconds. It will take
about 10 seconds to complete the initializing. Be
sure to continue supplying power to the camera
while initializing.
Notes:
• Never press both the buttons A and B at a time.
• Try again if the previous initializing failed.