Troubleshooting & repair, Procedure, Fan motor and fan removal and replacement – Lincoln Electric IDEALARC SP-250 Manuel d'utilisation
Page 97
F-50
TROUBLESHOOTING & REPAIR
F-50
IDEALARC SP-250
PROCEDURE
See Figure F.18 for fan motor and fan
removal components.
FIGURE F.18 - Fan Motor and Fan
Removal Components
1.
Remove the Case Back screws.
2.
Remove the gas solenoid using a
3/4" open end wrench.
3.
Using a 5/16” wrench, remove the 5
screws holding the fan motor mount-
ing bracket to the case back.
4.
Tilt the Case Back away from the
machine and remove the screws
holding the Case Back to the floor of
the machine using a 1/2" socket
wrench with extension.
5.
Loosen the two screws holding the
reconnect panel in place and a slide
the reconnect panel from the frame.
6.
Remove the fan blade. Note fan
blade position on motor shaft for ref-
erence for replacing fan.
a. Pry the fan blade off the motor.
b.
Slide the fan blade off the motor
shaft.
FAN MOTOR AND FAN REMOVAL AND REPLACEMENT