Warning – KITCHENAID 8574116 Manuel d'utilisation

Page 21

Advertising
background image

21

Check operation

1. Read the Use and Care Guide that came with your

dishwasher.

2. Check that all parts have been installed and no steps

were skipped.

3. Check that you have all the tools you used.

4. Start dishwasher and allow it to complete the shortest

wash cycle. After the first two minutes, unlatch door,
wait five seconds, then open door.

5. Check to see that there is water in the bottom of the

dishwasher tub. Check that dishwasher is working
properly. If not, see “If dishwasher does not operate”
section.

6. Disconnect power or unplug dishwasher.

If dishwasher does not operate

First try the solutions suggested here to possibly avoid the
cost of a service call.

• Has the circuit breaker tripped or the house fuse blown?

• Is the door closed tightly and latched?

• Has the cycle been set correctly to start the dishwasher?

• Is the water turned on?

If none of these work, call 1-800-422-1230.

3. Hold the two panels together and push them up against

dishwasher leg and vinyl pad.

4. Reinstall the screws through the holes in the access

panel and the slots in the lower panel. Install right side
screw first.

5. Check that the lower edge of the lower panel contacts

the floor.

6. Tighten the screws.

Direct wire method:

Power supply cord method:

7.

Reconnect power or plug in dishwasher.

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death,
fire, or electrical shock.

WARNING

WARNING

Electrical Shock Hazard

Electrically ground dishwasher.

Connect ground wire to green ground connector in
terminal box.

Do not use an extension cord.

Failure to follow these instructions can result in death,
fire, or electrical shock.

Advertising