Warning, Connect to water supply – KITCHENAID W10078153B Manuel d'utilisation

Page 17

Advertising
background image

17

3. Connect the wires as follows using twist-on connectors

sized to connect direct wire to 16-gauge dishwasher
wire:

4. Form bare ground wire into a U-shaped hook. Wrap

ground wire hook clockwise around ground connector
and under the washer.

5. Securely tighten ground connector.

6. Tighten clamp connector or conduit connector screws.

7.

Reinstall terminal box cover with wires inside terminal
box. The cover must be outside the box on the left side.

8. Make sure no wires are pinched by cover.

WARNING

Electrical Shock Hazard

Electrically ground dishwasher.

Connect ground wire to green ground connector in
terminal box.

Do not use an extension cord.

Failure to follow these instructions can result in death,
fire, or electrical shock.

ground wire

washer

ground
connector

ground wire

screws

ADVERTENCIA

AVERTISSEMENT

Terminal box wire:
white
black
ground connector

Power supply wire:

white

black

ground wire

Option 2: Power supply cord method

1. Plug into a grounded 3 prong outlet.

2. Check that power supply cord does not touch

dishwasher motor or lower part of dishwasher tub.

Connect to water supply

Helpful Tip:

Compression fittings:

a. Slide nut onto copper tubing about 1" (2.5 cm).

b. Slide ferrule onto the tubing. Do not position ferrule

on the end of the tubing.

c. Put the tubing into the elbow as far as it will go.

d. Slide the nut and ferrule forward and start the nut

onto the elbow threads. Be gentle when handling and
positioning the copper tubing, it bends and kinks
easily.

1. To prevent vibration during operation, route the water

supply line so that it does not touch the dishwasher
base, frame or motor.

2. With copper tubing pushed into compression fitting as

far as it will go, use a wrench and tighten compression
fitting nut to elbow on water inlet valve.

3. Place paper towel under elbow. Turn on water supply

and check for leaks.

nut

ferrule

elbow

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death,
fire, or electrical shock.

WARNING

Advertising