Simplicity 1695906 - Manuel (Page 2)

Install the Discharge Chute
NOTE: Some models have the discharge chute already
installed.
Place discharge chute ( 1. M, Figure 5) over tabs on chute
ring (N) as shown.
Secure discharge chute with three carriage bolts ( 2. O) and
nuts (P).
Figure 5
Route Defl ector Cable & Clip (if included)
Figure 6
Figure 7
Figure 4
L
NOTE: If the chute rotation is slow or binding, loosen the
chute rotation screws (L, Figure 4) 1/4 turn.
M
N
O
P
P
P
3. Tighten hardware to 66 in-lbs (7.6 Nm).
4. Connect the wire harness (electric chute models only).
NOTE: Check all bolts and nuts in fl ange for tightness. Do not
overtighten.
Not
for
Reproduction