Closed caption system, Mts (multi-channel television sound) system – Symphonic CSTL20D6 Manuel d'utilisation

Page 14

Advertising
background image

EN

- 14 -

You can view specially labeled (cc) TV programs,
movies, news and pre-recorded tapes with either a
dialogue caption or text display.

CAPTION mode:

You can watch dramas, movies and

news while captioning the dialogues and the contents
of news.

TEXT mode:

You can watch half screen text informa-

tion if you want.

1-2:

You may get these captions or text information

by selecting either “1” or “2”. “2” is usually used for
a second language if available.

Not all programs are broadcast with closed cap-
tions. Your unit is designed to provide error-free
closed captions from high quality antenna, cable
and VCR signals. Conversely, poor quality sig-
nals are likely to result in caption errors or no
captions at all. Common signal conditions which
may cause caption errors are listed below:

Automobile ignition noise

Electric motor brush noise

Weak snowy reception on TV screen

Multiplex signal reception displaying picture
ghosts or airplane flutter

If the unit displays a black box on the TV
screen, this means that the unit is set to the
TEXT mode. To clear screen, select
“CAPTION1”, “CAPTION2” or “OFF”.

1

Press [SETUP] then press [K] or [L] to point
to “CAPTION”.

2

Press [ENTER] repeatedly to select the
desired caption menu “CAPTION1”,
“CAPTION2”, “TEXT1” or “TEXT2”.

If you select “OFF”, Closed Caption System set-
ting is canceled

.

3

Press [SETUP] to exit the menu.

Even if there is a power failure of any
kind, the unit will retain its memory for
this feature.

TO SELECT TV SOUND MODE

1

Press [AUDIO] repeatedly to select the MTS
output mode.

The output mode changes as described below
every time you press [AUDIO].

* Second Audio Program (SAP):

Sometimes broadcasters add another channel of
audio to the programs they air. This is usually a
secondary language or perhaps a radio station.

After 5 seconds, the current audio status will
disappear from the TV screen.

The initial setting is “STEREO”.

This setting is saved even if the unit is turned
off or the AC cord is unplugged.

TO CHECK THE SOUND STATUS

By pressing [DISPLAY], the status shown below
will appear on the display when you receive a broad-
cast on the unit tuner channel you are watching.

1) When a program is broadcast in stereo,

“STEREO” appears on the TV screen.

2) When a program is broadcast in second audio,

“SAP” appears on the TV screen.

3) When a program broadcast both in stereo and sec-

ond audio, “STEREO/SAP” appears on the TV
screen.

CLOSED CAPTION SYSTEM

- TV SET UP -

CHANNEL SET UP
V-CHIP SET UP
LANGUAGE [ENGLISH]

B

CAPTION

[OFF]

BACK LIGHT [BRIGHT]

- TV SET UP -

CHANNEL SET UP
V-CHIP SET UP
LANGUAGE [ENGLISH]

B

CAPTION

[CAPTION1]

BACK LIGHT [BRIGHT]

SETUP

ENTER

SETUP

MTS (Multi-Channel Television

Sound) System

AUDIO

NOTE

NOTE

STEREO

SAP

*

MONO

NOTE

STEREO

CH 123

STEREO/SAP

3)

1)

2)

Advertising